B2272 Ignition 1 Monitor Malfunction
Diagnostic trouble codes · Vehicles built from Jan 2007
DESCRIPTION
This DTC is output when a malfunction occurs in the IG output circuit, which is between the IG1 relay actuation circuit inside the main body ECU and the IG1 relay.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2272 |
IG1 relay actuation circuit inside main body ECU or other related circuit is malfunctioning |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER (IG1 RELAY MONITOR (INSIDE)) |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and turn the tester ON.
Select the following menu items: Body / Main Body ECU / Data List / IG1 Relay Mon2.
Read the display on the tester.
Main body ECU Tester Display
Measurement Item/Range
Normal Condition
Diagnosis Note
IG1 Relay Mon2
IG1 inner relay monitor / ON or OFF
ON: Engine switch on (IG)
OFF: Engine switch off
-
- OK:
- When the engine switch is turned on (IG), ON is displayed on the tester.
|
|
||||
| OK | |
| 2. CHECK SWITCH CONDITION (ENGINE SWITCH) |
Ensure the electrical key is inside the cabin.
Check that the power source mode changes as shown below each time the engine switch is pushed.
- OK:
- off → on (ACC) → on (IG) → off
|
|
||||
| OK | ||
| ||
| 3. INSPECT IG1 RELAY |
Remove the IG1 relay from the instrument panel junction block.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Specified Condition
3 - 5
10 kΩ or higher
3 - 5
Below 1 Ω
(when battery voltage applied to terminals 1 and 2)
|
|
||||
| OK | ||
| ||
