2005-2008 RAV4 · Service Manual ENGINE

B2274 ACC Monitor Malfunction

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

This DTC is output when a malfunction occurs in the ACC output circuit, which is between the ACC relay actuation circuit inside the main body ECU and the ACC relay.
DTC No.
DTC Detection Condition
Trouble Area
B2274
ACC relay actuation circuit inside main body ECU or other related circuit is malfunctioning
  1. Main body ECU
  2. ACC relay
  3. Wire harness

WIRING DIAGRAM

A126721E01

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (ACC RELAY MONITOR)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. Select the following menu items: Body / Main Body ECU / Data List / ACC Relay Mon.

  1. Read the display on the tester.

    Main body ECU:
    Item
    Measurement Item / Display (Range)
    Normal Condition
    Diagnostic Note
    ACC Relay Monitor
    ACC relay monitor / ON or OFF
    ON: Ignition switch on (ACC)
    OFF: Ignition switch off
    -

    OK:
    When the ignition switch is turned on (ACC), ON is displayed on the tester.



NG
Go to step 3
OK


2. CHECK SWITCH CONDITION (IGNITION SWITCH)
  1. Ensure the electrical key is inside the cabin.

  1. Check that the power source mode changes as shown below each time the ignition switch is pushed.

OK:
off → on (ACC) → on (IG) → off



NG
GO TO POWER SOURCE MODE DOES NOT CHANGE
OK

NORMAL

3. INSPECT ACC RELAY

  1. B060778E04
    Remove the ACC relay from the instrument panel junction block.

  1. Check the resistance of the relay.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)



NG
REPLACE ACC RELAY
OK


4. CHECK WIRE HARNESS (ACC RELAY - MAIN BODY ECU AND BODY GROUND)

  1. A126727E01
    Remove the ACC relay from the No. 5 relay block.

  1. Disconnect the E18 main body ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connections
    Specified Conditions
    Relay block ACC relay terminal 1 - E18-4 (ACCD)
    Below 1 Ω
    Relay block ACC relay terminal 2 - Body ground
    Below 1 Ω
    Relay block ACC relay terminal 1 or E18-4 (ACCD) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE INSTRUMENT PANEL JUNCTION BLOCK (MAIN BODY ECU)


← B2273 Ignition 2 Monitor Malfunction (from Nov 2005)B2275 STSW Monitor Malfunction (from Nov 2005) →