2005-2008 RAV4 · Service Manual ENGINE

B2275 STSW Monitor Malfunction

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

This DTC is output when the engine start request signal circuit inside the main body ECU is open or short.
DTC No.
DTC Detection Condition
Trouble Area
B2275
Engine start request signal circuit inside main body ECU or other related circuit is malfunctioning
  1. Main body ECU
  1. SFI system
  1. Wire harness

WIRING DIAGRAM

A122229E01

INSPECTION PROCEDURE


1. CHECK WHETHER DTC OUTPUT RECURS
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. Clear the DTCs.

  1. Depress the brake pedal with the ignition switch on (IG), wait at least 15 seconds, and check whether DTC B2275 recurs.

Result:
Display (DTC output)
Proceed to
B2275
A
No DTC output
B



B
END
A


2. CHECK MAIN BODY ECU (STSW VOLTAGE)

  1. A122230E03
    Disconnect the E20 main body ECU connector.

  1. With the shift lever in P or N, depress the clutch pedal (M/T) or brake pedal (A/T) fully.

  1. Measure the voltage between the ECU terminal and the body ground when operating the engine switch to crank the engine.

    HINT:
    The voltage is generated at terminal STSW for 0.3 seconds when the engine cranks.

    Standard voltage:
    Tester Connection
    Specified Condition
    E20-4 (STSW) - Body ground
    10 to 14 V



NG
Go to step 4
OK


3. CHECK WIRE HARNESS (MAIN BODY ECU - ECM)

  1. A126728E02
    Disconnect the E20 main body ECU connector.

  1. Disconnect the A12 ECM connector.

  1. Check the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E20-4 (STSW) - A12-14 (STSW)
    Below 1 Ω
    E20-4 (STSW) or A12-14 (STSW) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


4. CHECK WHETHER ENGINE STARTS
  1. Temporarily replace the instrument panel junction block (main body ECU) with a new or normally functioning one.

  1. Check that the engine starts normally.

    OK:
    Engine starts normally.



NG
GO TO SFI SYSTEM
OK

END (MAIN BODY ECU IS FAULTY)


← B2274 ACC Monitor Malfunction (from Nov 2005)B2276 ACCR Signal Circuit Malfunction (from Nov 2005) →