B2287 LIN Communication Master Malfunction
Diagnostic trouble codes · Vehicles built from Jan 2007
Also covers:
- B2289 Key Collation Waiting Time Over
DESCRIPTION
DTC B2287 is output when there is an abnormal LIN communication circuit between the main body ECU and the certification ECU. DTC B2289 is output when there is a malfunction in the immobiliser system.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2287 |
Communication or communication line is abnormal between main body ECU and certification ECU |
|
| B2289 |
Either of following conditions is met:
|
|


WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK WIRE HARNESS (MAIN BODY ECU - CERTIFICATION ECU) |
Disconnect the ID instrument panel junction block connector.

Disconnect the E63 certification ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Specified Condition
ID-9 (LIN1) - E63-10 (LIN)
Below 1 Ω
ID-9 (LIN1) or E63-10 (LIN) - Body ground
10 kΩ or higher
|
|
||||
| OK | |
| 2. CHECK CERTIFICATION ECU |
Temporarily replace the certification ECU with a new or normally functioning one.
Check for DTCs again.
- OK:
- No DTC is output.
|
|
||||
| OK | ||
| ||
