2005-2008 RAV4 · Service Manual BRAKE

CHECK FOR INTERMITTENT PROBLEMS

Troubleshooting · Vehicles built from Nov 2005


CHECK FOR INTERMITTENT PROBLEMS

HINT:
A momentary interruption (open circuit) in the connectors and/or wire harness between the sensors and ECUs can be detected by using the ECU Data List function of the intelligent tester.

  1. B127990E01
    Turn the ignition switch off and connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG).

  3. C122684E02
    Follow the prompts on the intelligent tester to display the Data List and select areas where a momentary interruption should be monitored.

    HINT:
    1. A momentary interruption (open circuit) cannot be detected for 3 seconds after the ignition switch is turned on (initial check).
    2. If the status remains on the ERROR display, check for continuity between the ECU and the sensors, or between ECUs.
    3. The ERROR display on the intelligent tester remains on for 1 second after the harness signal changes from a momentary interruption (open circuit) to the normal condition.

    Item (Display)
    Measurement Item /
    Range (Display)
    Normal Condition
    Diagnostic Note
    FR Speed Open
    FR speed sensor open detection / ERROR or NORMAL
    ERROR: Momentary interruption
    NORMAL: Normal
    -
    FL Speed Open
    FL speed sensor open detection / ERROR or NORMAL
    ERROR: Momentary interruption
    NORMAL: Normal
    -
    RR Speed Open
    RR speed sensor open detection / ERROR or NORMAL
    ERROR: Momentary interruption
    NORMAL: Normal
    -
    RL Speed Open
    RL speed sensor open detection / ERROR or NORMAL
    ERROR: Momentary interruption
    NORMAL: Normal
    -

  4. C122685
    While observing the screen, gently jiggle the connector or wire harness between the ECU and sensors, or between ECUs.

    OK:
    ERROR display does not change.

    HINT:
    The connector and/or wire harness have a momentary interruption (open circuit) if the display changes. Repair or replace the connector and wire harness if either of them is faulty.

← HOW TO PROCEED WITH TROUBLESHOOTING (from Nov 2005)TEST MODE PROCEDURE (Nov 2005 – Jul 2007) →