CHECK FOR INTERMITTENT PROBLEMS
Troubleshooting · Vehicles built from Aug 2008
Versions by build date: Nov 2005 – Jul 2008 from Aug 2008
| CHECK FOR INTERMITTENT PROBLEMS |
- HINT:
- A momentary interruption (open circuit) in the connectors and/or wire harness between the sensors and ECUs can be detected by using the ECU Data List function of the intelligent tester.
Turn the ignition switch off and connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Follow the prompts on the intelligent tester to display the Data List and select areas where a momentary interruption should be monitored.

- HINT:
- A momentary interruption (open circuit) cannot be detected for 3 seconds after the ignition switch is turned to ON (initial check).
- If the status remains on the ERROR display, check for continuity between the ECU and the sensors, or between ECUs.
- The ERROR display on the intelligent tester remains on for 1 second after the harness signal changes from a momentary interruption (open circuit) to normal condition.
- A momentary interruption (open circuit) cannot be detected for 3 seconds after the ignition switch is turned to ON (initial check).
ABS/VSC/TRC: Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
FR Speed Open
FR speed sensor open detection / ERROR or NORMAL
ERROR: Momentary interruption
NORMAL: Normal
-
FL Speed Open
FL speed sensor open detection / ERROR or NORMAL
ERROR: Momentary interruption
NORMAL: Normal
-
RR Speed Open
RR speed sensor open detection / ERROR or NORMAL
ERROR: Momentary interruption
NORMAL: Normal
-
RL Speed Open
RL speed sensor open detection / ERROR or NORMAL
ERROR: Momentary interruption
NORMAL: Normal
-
EFI Communication Open
EFI communication open detection / ERROR or NORMAL
ERROR: Momentary interruption
NORMAL: Normal
-
Yaw Rate Open
Yaw rate sensor open detection / ERROR or NORMAL
ERROR: Momentary interruption
NORMAL: Normal
-
Deceleration Open
Deceleration sensor open detection / ERROR or NORMAL
ERROR: Momentary interruption
NORMAL: Normal
-
Steering Open
Steering angle sensor open detection / ERROR or NORMAL
ERROR: Momentary interruption
NORMAL: Normal
-
Master Cylinder Open
Master cylinder pressure sensor open detection / ERROR or NORMAL
ERROR: Momentary interruption
NORMAL: Normal
-
While observing the screen, gently jiggle the connector or wire harness between the ECU and sensors, or between ECUs. If the display changes, the connector and/or wire harness is in momentary interruption (open circuit). Repair or replace the connector and/or wire harness, as one of them is faulty.
