B2276 ACCR Signal Circuit Malfunction
Diagnostic trouble codes · Vehicles built from Nov 2005
DESCRIPTION
This DTC is output when a malfunction is detected in the ACCR signal output by the main body ECU.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2276 |
ACCR output circuit inside main body ECU or other related circuit is malfunctioning |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK WHETHER DTC OUTPUT RECURS |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Clear the DTCs.
Check whether DTC B2276 recurs 50 seconds or more after the ignition switch is turned on (IG).
- Result:
Display (DTC output)
Proceed to
B2276
A
No DTC output
B
|
|
||||
| A | |
| 2. CHECK MAIN BODY ECU (ACCR VOLTAGE) |
Disconnect the E20 main body ECU connector.

Measure the voltage of the wire harness side connector when operating the engine switch to crank the engine.
- Standard voltage:
Tester Connection
Specified Condition
E20-11 (ACCR) - Body ground
10 to 14 V
|
|
||||
| OK | |
| 3. CHECK WIRE HARNESS (MAIN BODY ECU - ECM) |
Disconnect the E20 main body ECU connector.

Disconnect the A12 ECM connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
E20-11 (ACCR) - A12-13 (ACCR)
Below 1 Ω
E20-11 (ACCR) or A12-13 (ACCR) - Body ground
10 kΩ or higher
|
|
||||
| OK | |
| 4. CHECK MAIN BODY ECU |
Temporarily replace the main body ECU with a new or normally functioning one.
Check whether DTC B2276 recurs by repeating the "CHECK WHETHER DTC OUTPUT RECURS" procedures above.
- OK:
- No DTC is output.
|
|
||||
| OK | ||
| ||
