2005-2008 RAV4 · Service Manual ENGINE

Engine Switch Indicator Circuit

Circuit diagnosis · Vehicles built from Jan 2007

DESCRIPTION

Engine start conditions or system malfunctions can be checked by observing the status of the engine switch indicator light.
Engine switch indicator light condition 
Power Source Mode/Condition
Indicator Light Condition
Brake pedal released
Brake pedal depressed, shift lever in P or N
Off
OFF
Illuminates (green)
On (ACC, IG)
Illuminates (amber)
Illuminates (green)
Engine running
OFF
OFF
Steering lock not unlocked
Flashes (green) for 30 seconds
Flashes (green) for 30 seconds
System malfunction
Flashes (amber) for 15 seconds
Flashes (amber) for 15 seconds
Stop light switch with shift lever in P or N malfunction
Flashes (green) for 15 seconds
Flashes (green) for 15 seconds

WIRING DIAGRAM

A165876E01

INSPECTION PROCEDURE


1. INSPECT ENGINE SWITCH ASSEMBLY

  1. A109259E07
    Remove the engine switch.

  1. Apply the battery voltage of the switch, and check the illumination condition of the engine switch indicator light.

    NOTICE:
    1. If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator light does not illuminate.
    2. If the voltage is too low, the indicator light does not illuminate.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 11 (SWIL)
    Battery negative (-) → Terminal 4 (COM) or 5 (GND)
    Illuminates
    Battery positive (+) → Terminal 12 (INDS)
    Battery negative (-) → Terminal 4 (COM) or 5 (GND)
    Illuminates
    Battery positive (+) → Terminal 13 (INDW)
    Battery negative (-) → Terminal 4 (COM) or 5 (GND)
    Illuminates



NG
REPLACE ENGINE SWITCH ASSEMBLY
OK


2. CHECK WIRE HARNESS (ENGINE SWITCH - MAIN BODY ECU AND BODY GROUND)
A122429E03
  1. Disconnect the E31 engine switch connector.

  1. Disconnect the E19 and E20 main body ECU connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    E31-11 (SWIL) - E19-8 (SWIL)
    Below 1 Ω
    E31-12 (INDS) - E20-1 (INDS)
    Below 1 Ω
    E31-13 (INDW) - E20-8 (INDW)
    Below 1 Ω
    E31-5 (GND) - Body ground
    Below 1 Ω
    E31-4 (COM) - Body ground
    Below 1 Ω
    E31-11 (SWIL) or E19-8 (SWIL) - Body ground
    10 kΩ or higher
    E31-12 (INDS) or E20-1 (INDS) - Body ground
    10 kΩ or higher
    E31-13 (INDW) or E20-8 (INDW) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE INSTRUMENT PANEL JUNCTION BLOCK (MAIN BODY ECU)


← Engine does not Start (from Jan 2007)COMPONENTS (from Nov 2005) →