2005-2008 RAV4 · Service Manual ENGINE

B2285 Steering Lock Position Signal Circuit Malfunction

Diagnostic trouble codes · Vehicles built from Nov 2005

Also covers:

DESCRIPTION

The main body ECU and the steering lock ECU are connected by a cable and a LIN communication line. These DTCs are output when: 1) signals, transmitted through the cable and the communication line, do not match; or 2) a malfunction is detected in the circuit between the main body ECU and the steering lock ECU.
DTC No.
DTC Detection Condition
Trouble Area
B2285
Cable and LIN information between main body ECU and steering lock ECU are inconsistent
  1. Main body ECU
  1. Steering lock system
  1. Wire harness
B2288
After turning ignition switch from off to on (IG), steering wheel does not unlock for certain period of time (ECU unlocks steering wheel only when it receives unlock signal from LIN communication and cable)
  1. Main body ECU
  1. Steering lock system
  1. Wire harness

WIRING DIAGRAM

A126718E01

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (STEERING LOCK CONDITION)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. Select the following menu items: Body / Main Body ECU / Data List / Str Unlock SW.

  1. Read the display on the tester.


Main body ECU:
Item
Measurement Item / Display (Range)
Normal Condition
Diagnostic Note
Str Unlock SW
Steering lock condition / ON or OFF
ON: Steering is unlocked
OFF: Steering is locked
-

OK:
ON appears on the screen.



OK
REPLACE INSTRUMENT PANEL JUNCTION BLOCK (MAIN BODY ECU)
NG


2. CHECK WIRE HARNESS (MAIN BODY ECU - STEERING LOCK ECU)

  1. A122421E02
    Disconnect the E18 main body ECU connector.

  1. Disconnect the E6 steering lock ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E18-18 (SLP) - E6-4 (SLP1)
    Below 1 Ω
    E18-18 (SLP) or E6-4 (SLP1) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3. CHECK WHETHER ENGINE STARTS
  1. Temporarily replace the instrument panel junction block (main body ECU) with a new or normally functioning one.

  1. Check that the engine starts normally.

    OK:
    Engine starts normally.



NG
GO TO STEERING LOCK SYSTEM
OK

END (MAIN BODY ECU IS FAULTY)


← B2282 Vehicle Speed Signal Malfunction (+ B2283) (from Nov 2005)B2286 Runnable Signal Malfunction (from Nov 2005) →