2005-2008 RAV4 · Service Manual ENGINE

B2286 Runnable Signal Malfunction

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

The main body ECU and the ECM are connected by a cable and the CAN communication line. If the cable information and CAN information are inconsistent, this DTC is output.
DTC No.
DTC Detection Condition
Trouble Area
B2286
Cable and CAN information between main body ECU and ECM are inconsistent
  1. Main body ECU
  1. ECD system
  1. Wire harness

WIRING DIAGRAM

A126723E01

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (ENGINE CONDITION)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. Select the following menu items: Body / Main Body ECU / Data List / E/G Cond.

  1. Read the display on the tester.

    Main body ECU:
    Item
    Measurement Item/Display (Range)
    Normal Condition
    Diagnostic Note
    E/G Cond
    Engine condition / RUN or STOP
    RUN: Engine running
    STOP: Engine stopped
    -

    OK:
    When the engine is running, RUN is displayed on the tester.



OK
REPLACE INSTRUMENT PANEL JUNCTION BLOCK (MAIN BODY ECU)
NG


2. CHECK WIRE HARNESS (MAIN BODY ECU - ECM)

  1. A126728E06
    Disconnect the E20 main body ECU connector.

  1. Disconnect the A12 ECM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E20-2 (TACH) - A12-13 (TACH)
    Below 1 Ω
    E20-2 (TACH) or A12-13 (TACH) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3. CHECK WHETHER ENGINE STARTS
  1. Temporarily replace the main body ECU with a new or normally functioning one.

  1. Check that the engine starts normally.

    OK:
    Engine starts normally.



NG
GO TO ECD SYSTEM
OK

END (MAIN BODY ECU IS FAULTY)


← B2285 Steering Lock Position Signal Circuit Malfunction (+ B2288) (from Nov 2005)B2287 LIN Communication Master Malfunction (+ B2289) (from Nov 2005) →