2005-2008 RAV4 · Service Manual ENGINE

B2285 Steering Lock Position Signal Circuit Malfunction

Diagnostic trouble codes · Vehicles built from Jan 2007

Also covers:

DESCRIPTION

The main body ECU and the steering lock ECU are connected by a cable and a LIN communication line. These DTCs are output when: 1) signals, transmitted through the cable and the communication line, do not match; or 2) a malfunction is detected in the circuit between the main body ECU and the steering lock ECU.
DTC No.
DTC Detection Condition
Trouble Area
B2285
Cable and LIN information between main body ECU and steering lock ECU are inconsistent
  1. Main body ECU
  2. Steering lock system
  3. Wire harness or connector
B2288
After turning engine switch from off to on (IG), steering wheel does not unlock for certain period of time (ECU unlocks steering wheel only when it receives unlock signal from LIN communication and cable)
  1. Main body ECU
  2. Steering lock system
  3. Wire harness or connector

WIRING DIAGRAM

A165874E01

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (STEERING LOCK CONDITION)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG) and turn the tester ON.

  1. Select the following menu items: Body / Main Body ECU / Data List / Str Unlock SW.

  1. Read the display on the tester.

    Main body ECU 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Str Unlock SW
    Steering lock condition / ON or OFF
    ON: Steering is unlocked
    OFF: Steering is locked
    -

    OK:
    ON appears on the screen.



OK
REPLACE INSTRUMENT PANEL JUNCTION BLOCK (MAIN BODY ECU)
NG


2. CHECK WIRE HARNESS (MAIN BODY ECU - STEERING LOCK ECU)

  1. A122421E02
    Disconnect the E18 main body ECU connector.

  1. Disconnect the E6 steering lock ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    E18-18 (SLP) - E6-4 (SLP1)
    Below 1 Ω
    E18-18 (SLP) or E6-4 (SLP1) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK WHETHER ENGINE STARTS
  1. Temporarily replace the instrument panel junction block (main body ECU) with a new or normally functioning one.

  1. Check that the engine starts normally.

    OK:
    Engine starts normally.



NG
GO TO STEERING LOCK SYSTEM
OK

END (MAIN BODY ECU IS FAULTY)


← B2282 Vehicle Speed Signal Malfunction (+ B2283) (from Jan 2007)B2286 Runnable Signal Malfunction (from Jan 2007) →