2005-2008 RAV4 · Service Manual ENGINE

B2282 Vehicle Speed Signal Malfunction

Diagnostic trouble codes · Vehicles built from Jan 2007

Also covers:

DESCRIPTION

The main body ECU and the combination meter are connected with a cable and a CAN communication line. DTC B2282 is output when signals, transmitted through the cable and the communication line, do not match.
DTC No.
DTC Detection Condition
Trouble Area
B2282
Following conditions are met:
  1. Signals between main body ECU and combination meter are inconsistent
  2. Malfunction is detected in circuit between vehicle speed sensor and combination meter
  1. Main body ECU
  2. Combination meter
  3. Wire harness or connector
The skid control ECU converts these signals into 4-pulse signals and sends them to the combination meter. After these signals are converted into a more precise rectangular waveform by the waveform shaping circuit inside the combination meter, they are then transmitted to the main body ECU. The main body ECU determines the vehicle speed based on the frequencies of these pulse signals.
DTC No.
DTC Detection Condition
Trouble Area
B2283
When both conditions below are met:
  1. Vehicle speed decreases significantly
  2. Vehicle speed does not correspond with engine speed
  1. Main body ECU
  2. Combination meter
  3. Speed sensor
  4. Skid control ECU
  5. Wire harness or connector
A109248E03

WIRING DIAGRAM

A165873E01

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (VEHICLE SPEED SIGNAL)
  1. Connect the intelligent tester to the DLC3.

  1. Start the engine and turn the tester ON.

  1. Select the following menu items: Body / Main Body ECU / Data List / Vehicle Spd Sig.

  1. Read the display on the tester.

    Main body ECU 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Vehicle Spd Sig
    Vehicle speed signal / STOP or RUN
    STOP: Vehicle is stopped
    RUN: Vehicle is running
    -

    OK:
    STOP appears on screen.



NG
Go to step 2
OK

REPLACE INSTRUMENT PANEL JUNCTION BLOCK (MAIN BODY ECU)

2. CHECK WIRE HARNESS (MAIN BODY ECU - COMBINATION METER)

  1. A126729E01
    Disconnect the IC main body ECU connector.

  1. Disconnect the E22 combination meter connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    IC-8 (SPD) - E22-39 (+S)
    Below 1 Ω
    IC-8 (SPD) or E22-39 (+S) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK WHETHER ENGINE STARTS
  1. Temporarily replace the main body ECU with a new or normally functioning one.

  1. Check that the engine starts normally.

    OK:
    Engine starts normally.



NG
GO TO COMBINATION METER SYSTEM
OK

END (MAIN BODY ECU IS FAULTY)


← B2281 "P" Signal Malfunction (from Jan 2007)B2285 Steering Lock Position Signal Circuit Malfunction (+ B2288) (from Jan 2007) →