2005-2008 RAV4 · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built Aug 2007 – Jul 2008

Versions by build date: Aug 2007 – Jul 2008 from Aug 2008


1. DISCHARGE FUEL SYSTEM PRESSURE

HINT:
(Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


3. REMOVE FUEL TANK CAP

4. REMOVE FRONT FLOOR COVER
  1. Remove the 2 bolts and 3 clips.

  1. Remove the grommet and floor cover.


5. REMOVE NO. 1 FLOOR UNDER COVER

  1. A124659
    Remove the 2 nuts, clip and floor under cover.


6. DISCONNECT NO. 2 PARKING BRAKE CABLE ASSEMBLY

  1. A131635
    Remove the 2 bolts and disconnect the parking brake cable.


7. REMOVE NO. 1 FUEL TANK PROTECTOR
  1. Remove the 3 clips, 2 bolts and fuel tank protector.


8. DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY

  1. A124661E01
    Pinch and pull the main tube connector to disconnect the connector from the pipe.

    NOTICE:
    1. Check for foreign matter in the pipe and around the connector. Clean if necessary. Foreign matter may damage the O-ring or affect the O-ring's ability to seal between the pipe and connector.
    2. Do not use any tools to separate the pipe and connector.
    3. Do not forcefully bend or twist the nylon tube.
    4. Check for foreign matter on the pipe seal surface. Clean if necessary.
    5. Put the pipe and connector ends in plastic bags to prevent damage and foreign matter contamination.
    6. If the pipe and connector are stuck together, pinch the connector between your fingers and turn it carefully to disconnect it.

  1. Disconnect the purge line hose from the pipe.


9. DISCONNECT FUEL TANK TO FILLER PIPE HOSE

A173328
  1. Disconnect the filler pipe hose from the fuel tank.


10. DISCONNECT FUEL TANK BREATHER HOSE

  1. A131627
    Disconnect the breather hose from the fuel tank.


11. DISCONNECT FUEL EMISSION HOSE

  1. A173329
    Remove the fuel emission hose.


12. REMOVE FUEL TANK FILLER PIPE
  1. Remove the 3 bolts and filler pipe protector.

  1. Remove the 2 bolts and filler pipe.


13. REMOVE FUEL TANK ASSEMBLY
  1. Set a transmission jack underneath the fuel tank.

  1. A173330
    Remove the 6 bolts and 3 fuel tank bands.

  1. Slightly lower the transmission jack.

    NOTICE:
    Be careful not to cut the wirings.

  1. A173331E01
    Fold back approximately half of each cushion rubber so that the wire harness can be detached from the fuel tank in the step below.

  1. Disconnect the fuel pump connector and sender gauge connector.

    NOTICE:
    1. Before this procedure, check the connector for dirt, mud or other contamination.
    2. Do not use any tools in this procedure.

  1. Detach the wire harness from the 4 clamps and remove the fuel tank.


14. DISCONNECT FUEL EMISSION HOSE

  1. A124674
    Remove the purge line hose, air inlet line hose and EVAP line tube from the fuel pump.


15. DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY

  1. A124669
    Remove the joint clip and fuel tank main tube.

    CAUTION:
    1. Before removing the tube joint clip, check for foreign matter around the clip. Clean if necessary.
    1. Keep the O-ring free of foreign matter, as it becomes contaminated easily.
    1. Do not use any tools in this procedure.
    1. Do not forcefully bend or twist the tube.
    1. Put the tube in a plastic bag to prevent damage and contamination.
    1. If the fuel suction plate and tube are stuck together, pinch the tube and turn it carefully to disconnect it.
    1. Be careful not to damage the clip. If the clip is damaged, replace it.


16. REMOVE FUEL TANK VENT TUBE SET PLATE

  1. A124675
    Remove the 8 bolts and set plate.


17. REMOVE FUEL SUCTION WITH PUMP ASSEMBLY

  1. A124676
    Disconnect the fuel hose and remove the fuel suction with pump assembly from the fuel tank.

    NOTICE:
    1. Do not damage the wire harness.
    2. Do not separate the tube indicated in the illustration (Click here).

  1. A126699E02
    Remove the gasket from the fuel suction plate.


18. REMOVE FUEL TANK MAIN TUBE SUB-ASSEMBLY

  1. A124672
    Remove the tube from the fuel tube clamps.


19. REMOVE NO. 1 FUEL EVAPORATION TUBE SUB-ASSEMBLY
  1. Remove the tube from the fuel tube clamps.


20. REMOVE FUEL TUBE GROMMET
  1. Remove the 3 tube grommets and No. 5 fuel tube clamp from the fuel tank.


21. REMOVE FUEL TANK CUSHION

  1. A124667
    Remove the 7 fuel tank cushions from the fuel tank.


22. REMOVE FUEL SENDER GAUGE ASSEMBLY

  1. A124670
    Remove the 5 screws and sender gauge.

← COMPONENTS (from Aug 2008)REMOVAL (from Aug 2008) →