2005-2008 RAV4 · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built from Nov 2005

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE FRONT SEAT HEADREST ASSEMBLY

3. REMOVE FRONT SEAT TRACK BRACKET OUTER COVER LH
  1. Lift up the seat track adjusting handle and move the seat to the foremost position.

  1. B137715
    Using a screwdriver, detach the 4 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the outer cover in the direction indicated by the arrow in the illustration.


4. REMOVE FRONT SEAT TRACK BRACKET INNER COVER LH

  1. B137717
    Using a screwdriver, detach the 2 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the inner cover in the direction indicated by the arrow in the illustration.


5. REMOVE FRONT SEAT ASSEMBLY

  1. B131218
    Remove the 2 bolts on the rear side of the seat.

  1. Lift up the seat track adjusting handle and move the seat to the rearmost position.

  1. B131219
    Remove the 2 bolts on the front side of the seat.

  1. Lift up the seat track adjusting handle and move the seat to the center position. Also, operate the reclining adjuster release handle and move the seatback to the upright position.

  1. Disconnect the connector under the seat.

  1. Remove the seat.

    NOTICE:
    Be careful not to damage the vehicle body.

← COMPONENTS (from Aug 2008)DISASSEMBLY (Nov 2005 – Dec 2006) →