2005-2008 RAV4 · Service Manual BODY

DISASSEMBLY

Removal / installation · Vehicles built Nov 2005 – Dec 2006

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2008 from Aug 2008

CAUTION:
Wear protective gloves. Sharp areas on the seat frame (with adjuster) may injure your hands.

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. REMOVE VERTICAL ADJUSTER COVER LH (for Driver Side)

  1. B131224
    Using a screwdriver, detach the 2 claws and remove the cover.

    HINT:
    Tape the screwdriver tip before use.


2. REMOVE VERTICAL ADJUSTING HANDLE LH (for Driver Side)

  1. B131225
    Remove the 2 screws and handle.


3. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH (for Driver Side)

  1. B131223
    Raise the reclining adjuster release handle to reveal the claw. Using a screwdriver, detach the claw and remove the release handle.

    HINT:
    Tape the screwdriver tip before use.


4. REMOVE RECLINING ADJUSTER RELEASE HANDLE RH (for Front Passenger Side)

HINT:
Use the same procedures described for the driver side.


5. REMOVE FRONT SEAT CUSHION SHIELD LH (for Driver Side)

  1. B131221
    Disconnect the 2 rubber bands of the front seatback board or front seatback cover from the front seat frame (with adjuster).

  1. B131226
    Remove the 2 screws.

  1. Using a screwdriver, detach the 3 claws and remove the cushion shield.

    HINT:
    Tape the screwdriver tip before use.


6. REMOVE FRONT SEAT CUSHION SHIELD RH (for Front Passenger Side)

  1. B131221
    Disconnect the 2 rubber bands of the front seatback board or front seatback cover from the front seat frame (with adjuster).

  1. B131227
    Remove the 2 screws.

  1. Using a screwdriver, detach the 3 claws and remove the cushion shield.

    HINT:
    Tape the screwdriver tip before use.


7. REMOVE FRONT SEAT CUSHION INNER SHIELD LH

  1. B131228
    Remove the screw.

  1. Using a screwdriver, detach the claw and clip. Then remove the inner shield.

    HINT:
    Tape the screwdriver tip before use.


8. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH
  1. for Driver Seat:
    Disconnect the 2 connectors and detach the 3 clamps.

  1. for Passenger Seat:
    Disconnect the 2 connectors and detach the 3 clamps.

  1. B133640
    Remove the nut and seat belt.


9. REMOVE FRONT SEAT CUSHION COVER
  1. w/ Seat Heater System and Occupant Detection Sensor:
    Disconnect the connector.

  1. B131230E01
    Using a clip remover, remove the 2 clips.

  1. Detach the 2 hooks on the seat cushion front side.

  1. Using a screwdriver, detach the hooks and remove the seat cushion cover (with pad).

    HINT:
    Tape the screwdriver tip before use.

  1. B131232E01
    Remove the 15 hog rings and seat cushion cover from the seat cushion pad.


10. REMOVE FRONT SEAT CUSHION HEATER (w/ Seat Heater System)

  1. B134550E01
    Cut off the 10 tack pins which fasten the seat heater, and then remove the seat cushion heater from the seat cushion cover.

    NOTICE:
    Be careful not to damage the seat cushion cover and seat heater.


11. REMOVE FRONT SEATBACK BOARD SUB-ASSEMBLY LH (w/ Seatback Board)

  1. B131245
    Open the lower part of the seatback board. Then remove the 2 screws.

  1. B131244
    Pull the seatback board in the direction indicated by the arrow in the illustration to detach the 2 claws. Then, remove the seatback board.


12. REMOVE FRONT SEATBACK COVER

  1. B131240E01
    w/ Seatback Board:
    Remove the 5 hog rings

  1. w/ Seatback Board:
    Using a screwdriver, detach the hooks.

    HINT:
    Tape the screwdriver tip before use.

  1. B131239E01
    w/o Seatback Board:
    Open the 2 zippers.

  1. B131238E01
    w/o Seatback Board:
    Lift up the seatback cover and remove the 3 hog rings.

  1. B060977E01
    Detach the 4 claws and remove the 2 headrest supports.

  1. B131236
    Remove the nut and move the 2 seatback cover brackets.

  1. Remove the seatback cover (with pad) from the seat frame (with adjuster).

  1. B131241E01
    Remove the 11 hog rings and seatback cover from the seatback pad.


13. REMOVE FRONT SEATBACK HEATER (w/ Seat Heater System)

  1. B131243E01
    Cut off the 6 tack pins which fasten the seat heater, and then remove the seat cushion heater from the seat cushion cover.

    NOTICE:
    Be careful not to damage the seat cushion cover and seat heater.


14. REMOVE RECLINING ADJUSTER LOWER INSIDE COVER LH

  1. B131247
    Remove the screw.

  1. Detach the claw and remove the inside cover.


15. REMOVE RECLINING ADJUSTER LOWER INSIDE COVER RH

HINT:
Use the same procedures described for the LH side.


16. REMOVE RECLINING ADJUSTER UPPER INSIDE COVER LH

  1. B131248
    Remove the screw and inside cover.


17. REMOVE RECLINING ADJUSTER UPPER INSIDE COVER RH
  1. Remove the screw and inside cover.


18. REMOVE FRONT SEAT CUSHION LOWER SHIELD LH

  1. B131249E01
    Using a screwdriver, detach the claw and remove the lower shield.

    HINT:
    Tape the screwdriver tip before use.


19. REMOVE FRONT SEAT CUSHION LOWER SHIELD RH

HINT:
Use the same procedures described for the LH side.


20. REMOVE SEAT POSITION AIRBAG SENSOR (for Driver Side)

  1. B127917E01
    Remove the seat slide position sensor protector from the seat position sensor.

  1. Using a T30 "torx" socket, remove the "torx" screw and seat position sensor.

  1. Disconnect the connector.

← REMOVAL (from Nov 2005)DISASSEMBLY (Jan 2007 – Jul 2008) →