2005-2008 RAV4 · Service Manual BODY ELECTRICAL

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Nov 2005

HINT:
Use these procedures to troubleshoot the audio and visual system.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.BASIC INSPECTION
    1. Turn the ignition switch on (ACC).

    2. Check whether or not the display appears on the radio and navigation assembly.

      ResultĀ 
      Result
      Proceed to
      Display appears
      A
      Display does not appear
      B


    B.
    A

    4.PROBLEM SYMPTOMS TABLE
      ResultĀ 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B

    B.
    A

    5.OVERALL ANALYSIS AND TROUBLESHOOTING
    1. Terminals of ECU (Click here)

    2. Inspect front No. 1 speaker (Click here)

    3. Inspect rear No. 1 speaker (Click here)

    NEXT

    6.ADJUST, REPAIR OR REPLACE
      NEXT

      ← SYSTEM DESCRIPTION (from Nov 2005)IDENTIFICATION OF NOISE SOURCE (from Nov 2005) →