2005-2008 RAV4 · Service Manual BODY ELECTRICAL

Radio Broadcast cannot be Received (Bad Reception)

Circuit diagnosis · Vehicles built from Nov 2005

INSPECTION PROCEDURE


1. CHECK IF RADIO AUTO-SEARCH FUNCTIONS PROPERLY
  1. Perform the auto-search of the radio and check that it functions normally.

    OK:
    Radio auto-search functions normally.



OK
PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2. CHECK RADIO AND NAVIGATION ASSEMBLY (ANT VOLTAGE)

  1. E126416E01
    Measure the voltage of the radio and navigation assembly.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E52-8 (ANT) - Body ground
    Ignition switch on (ACC), radio switch ON
    10 to 14 V



NG
REPLACE RADIO AND NAVIGATION ASSEMBLY
OK


3. CHECK OPTIONAL COMPONENTS
  1. Check if the telephone antenna and other optional components are installed.

    OK:
    Optional component(s) installed.



OK
REPLACE RADIO AND NAVIGATION ASSEMBLY
NG


4. CHECK ANTENNA FOR NOISE PRODUCTION
  1. With the ignition switch on (ACC), turn on the radio and choose the AM mode.

  1. Place the tip of a screwdriver on the antenna and check that noise is heard from the speaker.

    OK:
    Noise is heard.



OK
PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE
NG


5. CHECK RADIO AND NAVIGATION ASSEMBLY (ANTENNA)

  1. E108381
    Remove the antenna plug of the radio and navigation assembly.

  1. With the radio and navigation assembly connector connected, turn the ignition switch on (ACC).

  1. Turn on the radio and choose the AM mode.

  1. Place a flat-head screwdriver or a piece of metal, such as a thin wire, on the antenna jack of the radio and navigation assembly. Check that the noise is heard from the speakers.

    OK:
    Noise is heard.



NG
REPLACE RADIO AND NAVIGATION ASSEMBLY
OK

PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE


← CD Sound Skips (from Nov 2005)No Image Appears on Multi-display (from Nov 2005) →