2005-2008 RAV4 · Service Manual BODY ELECTRICAL

Radio Receiver Power Source Circuit

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

This circuit provides power to the radio receiver.

WIRING DIAGRAM

I101984E05

INSPECTION PROCEDURE


1. INSPECT FUSE (RAD NO. 1, ACC)
  1. Remove the ACC fuse from the instrument panel junction block.

  1. Remove the RAD NO. 1 fuse from the engine room No. 2 relay block.

  1. Measure the resistance of the fuses.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2. CHECK WIRE HARNESS (RADIO RECEIVER - BATTERY AND BODY GROUND)
E106746E10
  1. Disconnect the E90 receiver connector.

  1. Measure the voltage and resistance of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E90-4 (B) - Body ground
    Always
    10 to 14 V
    E90-3 (ACC) - Body ground
    Ignition switch on (ACC)
    10 to 14 V

    Standard resistance:
    Tester Connection
    Specified Condition
    E90-7 (GND) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE RADIO RECEIVER ASSEMBLY


← Speed Signal Circuit (from Nov 2005)COMPONENTS (from Nov 2005) →