2005-2008 RAV4 · Service Manual BODY ELECTRICAL

Speed Signal Circuit

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

This circuit sends a speed signal from the combination meter to the radio receiver.

WIRING DIAGRAM

I102036E02

INSPECTION PROCEDURE


1. CHECK OPERATION OF SPEEDOMETER
  1. Drive the vehicle and check if the function of the speedometer on the combination meter is normal.

    OK:
    Actual speed and the speed indicated on the speedometer are the same.

    HINT:
    The vehicle speed sensor is functioning normally when the indication on the speedometer is normal.



NG
GO TO METER / GAUGE SYSTEM
OK


2. CHECK WIRE HARNESS (RADIO RECEIVER - COMBINATION METER)

  1. I102039E01
    Disconnect the E92 receiver connector.

  1. Disconnect the E22 meter connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E92-3 (SPD) - E22-39 (+S)
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE RADIO RECEIVER ASSEMBLY


← Speaker Circuit (from Nov 2005)Radio Receiver Power Source Circuit (from Nov 2005) →