P1550 Battery Current Sensor Circuit
Diagnostic trouble codes · Vehicles built from Aug 2007
Also covers:
- P1551 Battery Current Sensor Circuit Low
- P1552 Battery Current Sensor Circuit High
DESCRIPTION


The battery current sensor installed on the negative (-) battery terminal detects the amount of current supplied from the generator.
The battery current sensor changes current to voltage (at the negative (-) battery terminal) and sends it to the ECM. The ECM controls the voltage of the generator based on the signals from the battery current sensor.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| P1550 |
The following condition continues for 10 seconds or more with the ignition switch to the ON position (1 trip detection logic):
|
|
| P1551 |
Battery current sensor output value is 0.2 V or less for 0.5 seconds or more with the ignition switch to the ON position (1 trip detection logic): |
|
| P1552 |
Battery current sensor output value is 4.8 V or more for 0.5 seconds or more with the ignition switch to the ON position (1 trip detection logic): |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was running or stopped, whether the engine was warmed up or not, whether the air-fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction (Click here).
| 1. INSPECT BATTERY CURRENT SENSOR ASSEMBLY |
Disconnect the battery current sensor connector.

Measure the resistance of the battery current sensor.
- Standard resistance:
Tester Connection
Specified Condition
VC5 (2) - E2 (4)
3 to 10 kΩ
VC5 (2) - IB (3)
Below 0.5 kΩ
IB (3) - E2 (4)
3 to 10 kΩ
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (BATTERY CURRENT SENSOR - ECM) |
Disconnect the battery current sensor connector.

Disconnect the ECM connectors.
Measure the resistance of the wire harness side connectors.
- Standard resistance (Check for open):
Tester Connection
Specified Condition
IB (B31-3) - IB (B96-100)
Below 1 Ω
VC5 (B31-2) - VCIB (B96-80)
Below 1 Ω
E2 (B31-4) - EIB (B96-101)
Below 1 Ω
THB (B31-1) - THB (B96-103)
Below 1 Ω
- Standard resistance (Check for short):
Tester Connection
Specified Condition
IB (B31-3) or IB (B96-100) - Body ground
10 kΩ or higher
VC5 (B31-2) or VCIB (B96-80) - Body ground
10 kΩ or higher
THB (B31-1) or THB (B96-103) - Body ground
10 kΩ or higher
|
|
||||
| OK | ||
| ||
