INSTALLATION
Removal / installation · Vehicles built Jan 2007 – Jul 2007
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007
| 1. INSTALL CLUTCH PEDAL ASSEMBLY |
![]() ![]() |
Install the clutch pedal.
Install the 2 bolts.
- Torque:
- 19 N*m{ 194 kgf*cm , 14 ft.*lbf }
| 2. CONNECT CLUTCH START SWITCH CONNECTOR (w/ Entry and Start System) |
Install the clutch start switch with the nut.
- Torque:
- 16 N*m{ 160 kgf*cm , 12 ft.*lbf }
Connect the clutch start switch connector.
| 3. CONNECT CLUTCH START CANCEL SWITCH CONNECTOR (w/ Cruise Control System) |
Connect the switch connector.
For 1AZ-FE, 2AZ-FE, refer to the following procedures (Click here).
For 2AD-FTV, 2AD-FHV, refer to the following procedures (Click here).
| 4. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY (w/ Knee Airbag) |
![]() ![]() |
Connect the connector.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
Install the driver side knee airbag with the 4 bolts.
- Torque:
- 10 N*m{ 101 kgf*cm , 7 ft.*lbf }
| 5. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag) |
![]() ![]() |
Attach the 8 claws to install the lower instrument panel finish panel.
Install the 2 screws.
| 6. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
![]() ![]() |
Attach the 2 claws to install the instrument panel under cover.
Install the 2 screws.
| 7. INSTALL INSTRUMENT PANEL SAFETY PAD COVER |
Attach the 6 clips and 5 claws to install the instrument panel.
Connect the connectors and clamps.
Install the 2 bolts and 2 screws.


Connect the passenger airbag connector.
Install the 2 bolts to the passenger airbag.

- Torque:
- 20 N*m{ 204 kgf*cm , 15 ft.*lbf }
| 8. CHECK FLUID LEVEL IN RESERVOIR |
Check the fluid level in the reservoir (Click here).




