2005-2008 RAV4 · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built Nov 2005 – Dec 2006

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007


1. INSTALL CLUTCH PEDAL ASSEMBLY

C128470E02
  1. Install the clutch pedal.

  1. Install the 2 bolts.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }


2. CONNECT CLUTCH START SWITCH CONNECTOR (w/ Entry and Start System)
  1. Install the clutch start switch with the nut.

    Torque:
    16 N*m{ 160 kgf*cm , 12 ft.*lbf }

  1. Connect the clutch start switch connector.


3. CONNECT CLUTCH START CANCEL SWITCH CONNECTOR (w/ Cruise Control System)
  1. Connect the switch connector.
    For 1AZ-FE, 2AZ-FE, refer to the following procedures (Click here).
    For 2AD-FTV, 2AD-FHV, refer to the following procedures (Click here).


4. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY (w/ Knee Airbag)

B127987
  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Install the driver side knee airbag with the 4 bolts.

    Torque:
    10 N*m{ 101 kgf*cm , 7 ft.*lbf }


5. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)

B132919
  1. Attach the 8 claws to install the lower instrument panel finish panel.

  1. Install the 2 screws.


6. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

B129996
  1. Attach the 2 claws to install the instrument panel under cover.

  1. Install the 2 screws.


7. INSTALL INSTRUMENT PANEL SAFETY PAD COVER
  1. Attach the 6 clips and 5 claws to install the instrument panel.

  1. Connect the connectors and clamps.

  1. Install the 2 bolts and 2 screws.

    B129870

  1. Connect the passenger airbag connector.

  1. B129886
    Install the 2 bolts to the passenger airbag.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }


8. CHECK FLUID LEVEL IN RESERVOIR
  1. Check the fluid level in the reservoir (Click here).

← REASSEMBLY (from Nov 2005)INSTALLATION (Jan 2007 – Jul 2007) →