2005-2008 RAV4 · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built from Nov 2005


1. INSTALL LICENSE PLATE LIGHT ASSEMBLY (w/o Tire Carrier)

B140226
  1. Install the light as shown in the illustration.

  1. Install the screw.

  1. Connect the connector.


2. INSTALL LICENSE PLATE LIGHT ASSEMBLY

B135719
  1. Install the light as shown in the illustration.

  1. Connect the connector.


3. INSTALL REAR BUMPER COVER (for Bumper Attached Type)

  1. B127952E01
    Put protective tape under the quarter panel.

  1. w/ License Light:
    Install the 2 license plate lights (Click here).
    Connect the license plate light connector.

  1. w/ Fog Light:
    Connect the 2 fog light connectors.

  1. Attach the 12 claws to install the bumper cover.

  1. B127950E01
    Install the 9 screws and 7 clips.


4. INSTALL BACK DOOR LOWER OUT SIDE GARNISH SUB-ASSEMBLY (w/ Tire Carrier)
  1. Install the 2 license plate lights (Click here).

  1. B127969
    Connect the connector.

  1. Attach the 6 clips and 3 nuts.

  1. install the back door outside garnish.


5. INSTALL BACK DOOR OUT SIDE GARNISH (w/o Tire Carrier)
  1. Install the 2 license plate lights (Click here).

  1. B127969
    Connect the connector.

  1. Attach the 6 clips and 3 nuts.

  1. install the back door outside garnish.


6. INSTALL BACK DOOR TRIM BOARD (for Back Door Attached Type)
  1. Install the back door trim pocket with the 5 screws.

  1. B129943
    Attach the 13 clips to install the trim board.


7. INSTALL BACK DOOR SIDE GARNISH RH (for Back Door Attached Type)

HINT:
Use the same procedures described for the LH side.


8. INSTALL BACK DOOR SIDE GARNISH LH (for Back Door Attached Type)

  1. B129945
    Attach the 2 claws and 2 clips to install the garnish.


9. INSTALL BACK DOOR CENTER GARNISH (for Back Door Attached Type)

  1. B129944
    Attach the 4 claws and 4 clips to install the garnish.


10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
← REASSEMBLY (from Nov 2005)COMPONENTS (from Nov 2005) →