2005-2008 RAV4 · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built from Nov 2005

HINT:
  1. Use the same procedures for the RH and LH sides.
  2. The procedures listed below are for the LH side.


1. INSTALL WIPER RUBBER

  1. I030020E01
    Install the 2 packing plates to the rubber.

    NOTICE:
    Install the packing plates facing the proper direction.

  1. B131950
    Install the wiper rubber to the claw of the wiper blade in the direction indicated by the arrow in the illustration.

    HINT:
    Install the wiper rubber so that the head part (large side) of the wiper rubber faces the arm axle side.

  1. B108990E02
    Attach the head part (large side) of the wiper rubber to the rear end side claw of the wiper blade.

    NOTICE:
    Push the wiper blade into the grooves of the wiper rubber to attach them completely.


2. INSTALL WIPER RUBBER (for Plastic Type)

E125260
  1. Install the 2 packing plates to the rubber.

    NOTICE:
    Install the packing plates facing the proper direction.

  1. E125261
    Install the wiper rubber to the claw of the wiper blade in the direction indicated by the arrow in the illustration.

    HINT:
    Install the wiper rubber so that the head part (large side) of the wiper rubber faces the arm axle side.

  1. Attach the head part (large side) of the wiper rubber to the rear end side claw of the wiper blade.

    NOTICE:
    Push the wiper blade into the grooves of the wiper rubber to attach them completely.


3. INSTALL FRONT WIPER BLADE

  1. B113198
    Attach the claw to install the wiper blade.


4. INSTALL FRONT WIPER BLADE (for Plastic Type)

B136372E01
  1. Install the wiper blade.

  1. Install the holder as shown in the illustration.

← REMOVAL (from Nov 2005)COMPONENTS (from Nov 2005) →