PROBLEM SYMPTOMS TABLE
Troubleshooting · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007
- HINT:
- Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the ''Suspected area'' column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
| Symptom |
Suspected area |
See page |
| Noise |
1. Oil level (low) |
Click here
|
| 2. Oil grade (wrong) |
Click here
|
|
| 3. Gear (worn or damage) |
Click here
|
|
| 4. Bearing (worn or damaged) |
Click here
|
|
| Oil leakage |
1. Oil level |
Click here
|
| 2. Gasket |
Click here
|
|
| 3. Oil seal |
Click here
|
|
| 4. O-ring |
Click here
|
|
| Hard to shift or does not shift |
1. Synchronizer ring |
Click here
|
| 2. Shift key spring |
Click here
|
|
| Jumps out of gear |
1. Locking ball spring |
Click here
|
| 2. Shift fork (worn) |
Click here
|
|
| 3. Gear (worn or damaged) |
Click here
|
|
| 4. Bearing (worn or damaged) |
Click here
|
|
| The shift lever does not move (or the shift lever is difficult to move) to the 1st or 2nd position. |
1. Control cable (Adjustment) |
Click here
|
| It is possible to move the shift lever to the reverse position without pulling up the slider shaft. |
1. Control cable (Adjustment) |
Click here
|