2005-2008 RAV4 · Service Manual TRANSMISSION

ADJUSTMENT

Removal / installation · Vehicles built from Nov 2005


1. ADJUST TRANSAXLE CONTROL CABLE ASSEMBLY

HINT:
  1. After the shift lever or the shift cable is replaced, be sure to adjust the transmission control cable assembly.
  2. If the shift lever does not move (or the shift lever is difficult to move) to the 1st or 2nd position, or if it is possible to move the shift lever to the reverse position without pulling up the slider shaft, the length of the cable must be adjusted.

  1. C133959E02
    To release the lock (lock condition to lock release condition).

    HINT:
    While holding the shift lever in the reverse direction, lock the cable length adjustment mechanism of the select cable.

  1. C116736E02
    Pressing the shift and select lever shaft (*1) and pin (*2), push in pin (*3) and check that the shift and select lever shaft is secured at the 1st-2nd gear selected position (the shaft comes to a stop at the position 8 mm (0.31 in.) below the N position).

    1. Remove the stopper pin, release the lock, and reinsert the stopper pin.

  1. C127226E02
    Turn the shift lever in the reverse direction without pulling up the slider shaft.

  1. C133959E02
    While holding the shift lever in the reverse direction, lock the cable length adjustment mechanism of the select cable.

  1. C116736E01
    Release the pin that fixes the transmission outer lever.

    1. Pull the pin toward the left front side of the vehicle.

  1. C136703E01
    for new shift lever:
    Remove the stopper pin and dispose of it.

← REMOVAL (from Jan 2007)INSTALLATION (Nov 2005 – Dec 2006) →