2005-2008 RAV4 · Service Manual RESTRAINTS

INSTALLATION

Removal / installation · Vehicles built Nov 2005 – Dec 2006

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007

HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.
  3. A bolt without a torque specification is shown in the standard bolt chart (Click here).


1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

B131514
  1. Align the adjuster positioning hole with the claw, and install the adjuster with the 2 bolts as shown in the illustration.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }


2. INSTALL FRONT SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY LH

B131513
  1. Install the plate as shown in the illustration.

    HINT:
    Make sure the plate is firmly set into the garnish's claws.


3. INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH

NOTICE:
Do not disassemble the retractor.

  1. B131509E01
    Align the 2 claws with the seat belt positioning holes, and install the retractor of the outer belt with the bolt as shown in the illustration.

    Torque:
    8.5 N*m{ 87 kgf*cm , 75 in.*lbf }

  1. B131508
    Connect the pretensioner connector as shown in the illustration.

  1. B122779
    Connect the outer belt with the shoulder anchor's bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }


4. INSTALL CENTER PILLAR GARNISH LH

B129701
  1. Pass the outer belt anchor through the center pillar garnish.

  1. Attach the clip.

  1. Install the garnish with the 2 screws.


5. INSTALL CENTER PILLAR GARNISH LOWER LH

B131512
  1. Attach the 2 claws and 2 clips to install the garnish.

  1. Connect the floor anchor with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

  1. Attach the lap belt outer anchor cover.


6. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH

7. INSTALL REAR DOOR SCUFF PLATE LH (for Short Body)

  1. B129699
    Attach the 10 claws to install the scuff plate.


8. INSTALL REAR DOOR SCUFF PLATE LH (for Long Body)

  1. B129699
    Attach the 10 claws to install the scuff plate.


9. INSTALL FRONT DOOR SCUFF PLATE LH

  1. B129699
    Attach the 10 claws to install the scuff plate.


10. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH

11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
← INSPECTION (from Nov 2005)INSTALLATION (Jan 2007 – Jul 2007) →