INSTALLATION
Removal / installation · Vehicles built from Aug 2007
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007
- HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.
- A bolt without a torque specification is shown in the standard bolt chart (Click here).
| 1.
INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY |
 |
Align the adjuster positioning hole with the claw, and install the adjuster with the 2 bolts as shown in the illustration.
-
Torque:
- 42 N*m{
428 kgf*cm
, 31 ft.*lbf
}
| 2.
INSTALL FRONT SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY LH |
 |
Install the plate as shown in the illustration.
- HINT:
- Make sure the plate is firmly set into the garnish's claws.
| 3.
INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH |
 |
- NOTICE:
- Do not disassemble the retractor.
- Align the 2 claws with the seat belt positioning holes, and install the retractor of the outer belt with the bolt as shown in the illustration.
-
Torque:
- 8.5 N*m{
87 kgf*cm
, 75 in.*lbf
}
- Connect the pretensioner connector as shown in the illustration.
- Connect the outer belt with the shoulder anchor's bolt.
-
Torque:
- 42 N*m{
428 kgf*cm
, 31 ft.*lbf
}
| 4.
INSTALL CENTER PILLAR GARNISH LH |
 |
Pass the outer belt anchor through the center pillar garnish.
Attach the clip.
Install the garnish with the 2 screws.
| 5.
INSTALL CENTER PILLAR GARNISH LOWER LH |
 |
Attach the 2 claws and 2 clips to install the garnish.
Connect the floor anchor with the bolt.
-
Torque:
- 42 N*m{
428 kgf*cm
, 31 ft.*lbf
}
Attach the lap belt outer anchor cover.
| 6.
INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH |
|
| 7.
INSTALL REAR DOOR SCUFF PLATE LH (for Short Body)
|
 |
- Attach the 8 claws to install the scuff plate.
| 8.
INSTALL REAR DOOR SCUFF PLATE LH (for Long Body)
|
 |
- Attach the 9 claws and 2 clips to install the scuff plate.
| 9.
INSTALL FRONT DOOR SCUFF PLATE LH (for Short Body)
|
 |
- Attach the 10 claws to install the scuff plate.
| 10.
INSTALL FRONT DOOR SCUFF PLATE LH (for Long Body)
|
 |
- Attach the 10 claws to install the scuff plate.
| 11.
INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH |
|
| 12.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
|