P0500 Vehicle Speed Sensor "A"
Diagnostic trouble codes · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006 from Jan 2007
DESCRIPTION
Vehicles, which are equipped with ABS (Anti-lock Brake System), detect the vehicle speed using the skid control ECU and wheel speed sensor. The wheel speed sensor monitors the wheel rotation speed and sends a signal to the skid control ECU. The skid control ECU converts the wheel speed signal into a 4-pulse signal and transmits it to the ECM via the combination meter. The ECM determines the vehicle speed based on the frequency of the pulse signal.

| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0500 |
While vehicle being driven, no vehicle speed sensor signal to ECM. (1 trip detection logic: Automatic transaxle) (2 trip detection logic: Manual transaxle) |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.
| 1. CHECK OPERATION OF SPEEDOMETER |
Drive the vehicle and check whether the operation of the speedometer in the combination meter is normal.
- HINT:
- The vehicle speed sensor is operating normally if the speedometer reading is normal.
- If the speedometer does not operate, check it by following the procedure described in speedometer malfunction (Click here).
- The vehicle speed sensor is operating normally if the speedometer reading is normal.
|
|
||||
| OK | |
| 2. READ VALUE USING INTELLIGENT TESTER (VEHICLE SPEED) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Select the following menu items: Powertrain / Engine and ECT/ Data List / Vehicle Speed.
Drive the vehicle.
Read the value displayed on the tester.
- OK:
- Vehicle speeds displayed on tester and speedometer display are equal.
|
|
||||
| NG | |
| 3. CHECK COMBINATION METER ASSEMBLY (+S VOLTAGE) |
Disconnect the E22 combination meter connector.

Turn the ignition switch on (IG).
Measure the voltage between the terminal of the combination meter and the body ground.
- Standard voltage:
Tester Connections
Specified Conditions
+S (E22-39) - Body ground
9 to 14 V
Reconnect the combination meter connector.
|
|
||||
| OK | |
| 4. CHECK COMBINATION METER ASSEMBLY (SPD SIGNAL WAVEFORM) |
Shift the transmission gear selector lever to the neutral position.

Jack up the vehicle.
Turn the ignition switch on (IG).
Measure the voltage between the terminal of the combination meter and the body ground while the front wheel is turned slowly.
- Standard voltage:
Tester Connection
Specified Condition
+S (E22-39) - Body ground
Voltage generated intermittently
- HINT:
- The output voltage should fluctuate up and down, similarly to the diagram, when the wheel is turned slowly.
|
|
||||
| OK | |
| 5. CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECM) |
Disconnect the E22 combination meter connector.

Disconnect the A12 ECM connector.
Measure the resistance.
- Standard resistance (check for open):
Tester Connection
Specified Condition
+S (E22-39) - SPD (A12-8)
Below 1 Ω
- Standard resistance (check for short):
Tester Connection
Specified Condition
+S (E22-39) or SPD (A12-8) - Body ground
10 kΩ or higher
Reconnect the combination meter connector.
Reconnect the ECM connector.
|
|
||||
| OK | ||
| ||
