2005-2008 RAV4 · Service Manual BODY ELECTRICAL

Illumination Circuit

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

The radio receiver panel illuminates when the light control switch is in the TAIL or HEAD position.

WIRING DIAGRAM

I102012E01

INSPECTION PROCEDURE

NOTICE:
The vehicle is equipped with an SRS such as the airbag. Before servicing (include removal or installation of parts), be sure to read the precautionary notice for the airbag system (Click here).


1. CHECK WIRE HARNESS (RADIO RECEIVER - BATTERY AND BODY GROUND)
E106746E09
  1. Disconnect the E90 receiver connector.

  1. Measure the voltage and resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    E90-7 (GND) - Body ground
    Below 1 Ω
    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E90-10 (ILL+) - Body ground
    Light control switch OFF
    Below 1 V
    E90-10 (ILL+) - Body ground
    Light control switch TAIL or HEAD
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


2. CHECK VEHICLE EQUIPMENT
  1. Check if the steering pad switch is equipped on the vehicle.

    Result 
    Result
    Proceed to
    w/ Steering pad switch
    A
    w/o Steering pad switch
    B



B
PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE
A


3. CHECK WIRE HARNESS (STEERING PAD SWITCH - RADIO RECEIVER)

  1. I101971E04
    Disconnect the E10 cable connector.

  1. Disconnect the E49 receiver connector.

  1. Measure the resistance and voltage of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E10-4 (EAU) - E92-6 (SWG)
    Below 1 Ω
    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E10-12 (IL+2) - Body ground
    Light control switch
    TAIL or HEAD
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


4. INSPECT STEERING PAD SWITCH
  1. Disconnect the switch connector.

I102053E01
  1. Connect the positive (+) lead to terminal 5 (ILL+) and the negative (-) lead to terminal 8 (EAU) of the switch connector.

  1. Check if the illumination for the switch comes on.

    OK:
    Illumination for the steering pad switch comes on.



NG
REPLACE STEERING PAD SWITCH
OK


5. INSPECT SPIRAL CABLE SUB-ASSEMBLY

  1. I102015E11
    Disconnect the cable connector.

  1. Measure the resistance of the cable.

    Standard resistance:
    Tester Connection
    Specified Condition
    E10-4 (EAU) - 8 (EAU)
    Below 1 Ω
    E10-12 (IL+2) - 5 (IL+2)
    Below 1 Ω



NG
REPLACE SPIRAL CABLE SUB-ASSEMBLY
OK

PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE


← Steering Pad Switch Circuit (from Nov 2005)Speaker Circuit (from Nov 2005) →