2005-2008 RAV4 · Service Manual BODY ELECTRICAL

Steering Pad Switch Circuit

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

This circuit sends a signal from the steering pad switch to the radio receiver.

WIRING DIAGRAM

I102014E01

INSPECTION PROCEDURE

NOTICE:
The vehicle is equipped with an SRS such as the airbag. Before servicing (include removal or installation of parts), be sure to read the precautionary notice for the airbag system (Click here).


1. INSPECT STEERING PAD SWITCH ASSEMBLY
  1. Inspect the steering pad switch assembly (Click here).

    OK:
    Steering pad switch is normal.



NG
REPLACE STEERING PAD SWITCH
OK


2. CHECK WIRE HARNESS (SPIRAL CABLE - RADIO RECEIVER)

  1. I043625E06
    Disconnect the E92 receiver connector.

  1. Disconnect the E10 cable connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E92-7 (SW1) - E10-6 (AU1)
    Below 1 Ω
    E92-8 (SW2) - E10-5 (AU2)
    Below 1 Ω
    E92-6 (SWG) - E10-4 (EAU)
    Below 1 Ω
    E92-7 (SW1) - Body ground
    10 kΩ or higher
    E92-8 (SW2) - Body ground
    10 kΩ or higher
    E92-6 (SWG) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3. INSPECT SPIRAL CABLE SUB-ASSEMBLY

  1. I102015E03
    Disconnect the cable connector.

  1. Measure the resistance of the cable.

    Standard resistance:
    Tester Connection
    Specified Condition
    E10-4 (EAU) - 8 (EAU)
    Below 1 Ω
    E10-6 (AU1) - 10 (AU1)
    Below 1 Ω
    E10-5 (AU2) - 9 (AU2)
    Below 1 Ω



NG
REPLACE SPIRAL CABLE SUB-ASSEMBLY
OK

PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE


← Poor Sound Quality in All Modes (Low Volume) (from Nov 2005)Illumination Circuit (from Nov 2005) →