2005-2008 RAV4 · Service Manual BODY

ADJUSTMENT

Removal / installation · Vehicles built from Nov 2005

B057104E06

HINT:
  1. Centering bolts are used to mount the hood hinge and hood lock. The hood and hood lock cannot be adjusted with the centering bolts on. Substitute the centering bolts with standard bolts (with washers) when making adjustments.
  2. A bolt without a torque specification is shown in the standard bolt chart (Click here).


1. ADJUST HOOD SUB-ASSEMBLY

  1. B127320E01
    Adjust the hood's position.

    1. Loosen the hood's 4 hinge bolts.

    2. B127324E01
      Move the hood and adjust the clearance between the hood and front fender. Make sure that the clearance is within the standard range.

      Standard measurement:
      Area
      Specified Condition
      E
      3.5 +- 1.5 mm (0.138 +- 0.059 in.)
      G
      3.5 +- 1.5 mm (0.138 +- 0.059 in.)
      I
      3.5 +- 1.5 mm (0.138 +- 0.059 in.)

    3. Tighten the hood's 4 hinge bolts after the adjustment.

      Torque:
      13 N*m{ 133 kgf*cm , 10 ft.*lbf }

  1. B127325
    Adjust the cushion rubber so that the height of the hood and fender are aligned.

    1. B127326E01
      Raise or lower the hood's front end by turning the cushion rubber. Make sure that the clearance is within the standard range.

      Standard measurement:
      Area
      Specified Condition
      F
      0.6 +- 1.5 mm (0.024 +- 0.059 in.)
      H
      0.5 +- 1.5 mm (0.020 +- 0.059 in.)
      J
      0.0 +- 1.5 mm (0.000 +- 0.059 in.)

  1. B127328
    Adjust the hood lock.

    1. Loosen the 3 bolts.

    2. B127329
      Adjust the hood lock position so that the striker can enter it smoothly.

    3. Tighten the 3 bolts after the adjustment.

      Torque:
      8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

← REMOVAL (from Nov 2005)INSTALLATION (from Nov 2005) →