REMOVAL
Removal / installation · Vehicles built from Nov 2005
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2.
REMOVE RADIATOR SUPPORT OPENING COVER
|
 |
- Remove the 2 clips.
Partially remove the radiator support opening cover.
- HINT:
- It is not necessary to fully remove the radiator support opening cover. Partially remove it so that the bumper cover can be removed later.
| 3.
REMOVE HOOD LOCK ASSEMBLY |
 |
- w/ Hood courtesy switch:
Disconnect the connector.
Remove the 3 bolts.
- Disconnect the cable and remove the lock.
| 4.
REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY |
 |
- Detach the 3 claws and remove the lever.
Disconnect the cable.
| 5.
REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY |
 |
Remove the cable from the clamps, wire harness protector and wire harness grommet as shown in the illustration.

