REMOVAL
Removal / installation · Vehicles built Nov 2005 – Jul 2008
Versions by build date: Nov 2005 – Jul 2008 from Aug 2008
- HINT:
- Use the same procedures for the RH and LH sides.
- The procedures listed below are for the LH side.
- A bolt without a torque specification is shown in the standard bolt chart (Click here).
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2.
REMOVE FRONT FENDER LINER LH
|
 |
- Using a screwdriver, remove the clip and fender liner retainer.
Remove the screw, nut and bolt.
w/ Splash Shield:
Remove the front fender splash shield LH.
Partially remove the fender liner.
- HINT:
- It is not necessary to fully remove the fender liner. Partially remove it so that the bumper cover can be removed later.
| 3.
REMOVE FRONT FENDER LINER RH
|
 |
- HINT:
- Use the same procedures described for the LH side.
| 4.
REMOVE RADIATOR SUPPORT OPENING COVER
|
 |
- Remove the 2 clips.
Partially remove the radiator support opening cover.
- HINT:
- It is not necessary to fully remove the radiator support opening cover. Partially remove it so that the bumper cover can be removed later.
| 5.
REMOVE FRONT BUMPER COVER
|
 |
- Remove the 8 screws.
- Apply protective tape under the front fender and headlight.
Using a screwdriver, detach the 4 claws.
- HINT:
- Tape the screwdriver tip before use.
w/ Fog Light:
Disconnect the 2 fog light connectors.
w/ Headlight Cleaner:
Disconnect the headlight cleaner.
- Using a clip remover, remove the hood cushion center.
- Using a clip remover, remove the 4 clips and front bumper cover.
| 6.
REMOVE FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY UPPER |
 |
Disconnect the 2 horn connectors.
Remove the 2 bolts and reinforcement.
| 7.
REMOVE HEADLIGHT ASSEMBLY |
 |
Remove the 3 screws and bolt.
Disconnect the connectors and remove the headlight.