2005-2008 RAV4 · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built from Nov 2005

HINT:
  1. Use the same procedures for the RH side and LH sides.
  2. The procedures listed below are for the LH side.


1. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY

B131481
  1. Install the speaker with the 2 screws.

  1. Connect the connector.


2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
  1. Attach the 4 claws to install the speaker door grille.

  1. Attach the 7 claws to install the weatherstrip inner.

  1. B133485
    Attach the 2 claws to install the inside handle.

  1. B133484
    Attach the 10 clips to install the trim board.

  1. Install the 3 screws.

  1. B129164
    Attach the 3 claws to install the door inside handle bezel plug.

  1. B133479
    Attach the 12 claws to install the door assist grip.


3. INSTALL FRONT ARMREST BASE PANEL UPPER LH

B129161
  1. for Driver Side:
    Install the power window regulator master switch to the panel with the 3 screws.

  1. B137873
    for Passenger Side:
    Attach the 2 claws and install the power window regulator switch to the panel.

  1. Connect the switch connectors.

  1. B129160
    Attach the clip and 5 claws to install the panel (with the switch).


4. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

5. INSTALL DOOR ASSIST GRIP COVER LH

6. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

B129158
  1. Attach the clip and 3 claws to install the garnish.


7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
← REMOVAL (from Nov 2005)COMPONENTS (from Nov 2005) →