REMOVAL
Removal / installation · Vehicles built from Nov 2005
- HINT:
- Use the same procedures for the RH side and LH sides.
- The procedures listed below are for the LH side.
- Use the same procedures for the RH side and LH sides.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH |
![]() ![]() |
Using a screwdriver, detach the clip, 3 claws and remove the garnish.
- HINT:
- Tape the screwdriver tip before use.
| 3. REMOVE DOOR ASSIST GRIP COVER LH |
| 4. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH |
| 5. REMOVE FRONT ARMREST BASE PANEL UPPER LH |
![]() ![]() |
Using a screwdriver, detach the clip, 5 claws, and remove the panel (with the switch).
- HINT:
- Tape the screwdriver tip before use.
Disconnect the switch connectors.
for Driver Side:

Remove the 3 screws and power window regulator master switch from the panel.- NOTICE:
- Be careful when removing the screws as the switch may fall and become damaged.
for Passenger Side:

Using a screwdriver, detach the 2 claws and remove the power window regulator switch from the panel.- HINT:
- Tape the screwdriver tip before.
- NOTICE:
- Be careful when detaching the claws as the switch may fall and become damaged.
| 6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH |
![]() ![]() |
- HINT:
-


- Tape the screwdriver tip before use.
- Using a screwdriver, detach the 3 claws and remove the door inside handle plug.
- HINT:
- Tape the screwdriver tip before use.
Remove the 3 screws.

Using a screwdriver, detach the 10 clips, 2 claws and remove the trim.
- HINT:
- Tape the screwdriver tip before use.
- If the screwdriver cannot reach the clips, pull on the lower trim to remove it.
- Tape the screwdriver tip before use.
Using a screwdriver, detach the 7 claws and remove the weatherstrip inner.
- HINT:
- Tape the screwdriver tip before use.
Using a screwdriver, detach the 4 claws and remove the speaker door grille.
- HINT:
- Tape the screwdriver tip before use.
| 7. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY |
![]() ![]() |
Disconnect the connector.
Remove the 2 screws and speaker.




