ON-VEHICLE INSPECTION
Inspection · Vehicles built from Nov 2005
| DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| INSPECT INTEGRATION RELAY |
- NOTICE:
- The EFI relay is built into the integration relay (unit A: EFI MAIN).
- Some relays are built into the integration relay. The integration relay cannot be disassembled. If there is a malfunction in the circuit of the integration relay, replace the integration relay.
- The EFI relay is built into the integration relay (unit A: EFI MAIN).
Using a screwdriver, detach the 2 claws and disconnect the integration relay from the No. 1 engine room junction block.

- HINT:
- Tape the screwdriver tip before use.
Disconnect the 3 connectors from the integration relay.
Inspect the EFI relay.
Check the resistance of the EFI MAIN fuse.

If the result is not as specified, replace the EFI MAIN fuse.Measure the resistance of the integration relay.
- Standard resistance:
Tester Connection
Specified Condition
1A-4 - 1C-1
10 kΩ or higher
1A-4 - 1A-1
1A-4 - 1C-1
Below 1 Ω (when battery voltage is applied to terminals 1A-3 and 1A-2)
1A-4 - 1A-1
| CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
