2005-2008 RAV4 · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Aug 2007


DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

INSPECT INTEGRATION RELAY

NOTICE:
  1. The EFI relay is built into the integration relay (unit A: EFI MAIN).
  2. Some relays are built into the integration relay. The integration relay cannot be disassembled. If there is a malfunction in the circuit of the integration relay, replace the integration relay.

  1. A124574
    Using a screwdriver, detach the 2 claws and disconnect the integration relay from the engine room No. 1 junction block.

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the 3 connectors from the integration relay.

  1. Inspect the EFI MAIN relay.

    1. A107921E22
      Check the resistance of the EFI MAIN fuse.
      If the result is not as specified, replace the EFI MAIN fuse.

    2. Measure the resistance of the integration relay.

      Standard resistance:
      Tester Connection
      Specified Condition
      1C-1 - 1A-4
      10 kΩ or higher
      1C-1 - 1A-4
      Below 1 Ω (when battery voltage is applied to terminals 1A-2 and 1A-3)

      If the result is not as specified, replace the integration relay.

  1. Inspect the A/F relay.

    1. A137101E02
      Check the resistance of the A/F fuse.
      If the result is not as specified, replace the A/F fuse.

    2. Measure the resistance of the integration relay.

      Standard resistance:
      Tester Connection
      Specified Condition
      1C-1 - 1B-8
      10 kΩ or higher
      1C-1 - 1B-8
      Below 1 Ω (when battery voltage is applied to terminals 1B-6 and 1B-7)

      If the result is not as specified, replace the integration relay.


CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
← INSTALLATION (from Aug 2007)ON-VEHICLE INSPECTION (from Aug 2007) →