2005-2008 RAV4 · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Nov 2005


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE NO. 1 ENGINE COVER

  1. A123518
    Detach the 4 clips and remove the engine cover.


3. DISCONNECT ENGINE WIRE
  1. Disconnect the fuel pressure sensor connector.

  1. Disconnect the pressure discharge valve connector.

  1. Disconnect the turbo pressure sensor connector.

  1. Remove the grommet and nut and disconnect the glow plug wire harness.

  1. Remove the 2 nuts and disconnect the engine wire from the engine cover bracket.


4. REMOVE FUEL INLET PIPE SUB-ASSEMBLY

NOTICE:
After removing the fuel inlet pipe, cover the common rail and injection or supply pump with electrical tape to prevent dirt from entering them.

  1. A110774E01
    Remove the nut and fuel inlet pipe clamps.

  1. Using SST, remove the fuel inlet pipe.

    SST
    09023-38401  


5. REMOVE INJECTION PIPE SUB-ASSEMBLY

NOTICE:
After removing the injection pipe, cover the common rail and injector with electrical tape to prevent dust from entering them.

  1. A110775E02
    Remove the 2 bolts and 4 injection pipe clamps.

  1. Using SST, loosen the 4 nuts at the common rail end of the injection pipes.

    SST
    09023-38401  

  1. Using SST, loosen the 4 nuts at the injector end of the injection pipes.

    SST
    09023-38401  

  1. Remove the 4 injection pipes.


6. REMOVE COMMON RAIL ASSEMBLY

  1. A133254
    Using pliers, grip the claws of the clip and slide the clip to disconnect the pressure fuel hose.

  1. Remove the 2 bolts, common rail and intake manifold insulator.

← COMPONENTS (from Nov 2005)INSPECTION (from Nov 2005) →