REMOVAL
Removal / installation · Vehicles built from Aug 2008
Versions by build date: Nov 2005 – Jul 2008 from Aug 2008
- HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.
| 1.
REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH
|
 |
Using a screwdriver, detach the clip, 3 claws and remove the garnish.
- HINT:
- Tape the screwdriver tip before use.
| 2.
REMOVE FRONT UPPER ARMREST BASE PANEL LH
|
 |
Using a screwdriver, detach the clip, 5 claws, and remove the panel (with the switch).
- HINT:
- Tape the screwdriver tip before use.
Disconnect the switch connectors.
- for Driver Side:
Remove the 3 screws and power window regulator master switch from the panel.
- NOTICE:
- Be careful when removing the screws as the switch may fall and become damaged.
- for Passenger Side:
Using a screwdriver, detach the 2 claws and remove the power window regulator switch from the panel.
- HINT:
- Tape the screwdriver tip before.
- NOTICE:
- Be careful when detaching the claws as the switch may fall and become damaged.
| 3.
REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
|
 |
Using a screwdriver, detach the 12 claws and remove the door assist grip.
- HINT:
- Tape the screwdriver tip before use.
- Using a screwdriver, detach the 3 claws and remove the door inside handle plug.
- HINT:
- Tape the screwdriver tip before use.
- Remove the 3 screws.
Using a screwdriver, detach the 10 clips, 2 claws and remove the trim.
- HINT:
- Tape the screwdriver tip before use.
- If the screwdriver cannot reach the clips, pull on the lower trim to remove it.
Using a screwdriver, detach the 7 claws and remove the weatherstrip inner.
- HINT:
- Tape the screwdriver tip before use.
Using a screwdriver, detach the 4 claws and remove the speaker door grille.
- HINT:
- Tape the screwdriver tip before use.
| 4.
REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH |
 |
Disconnect the mirror connector labeled A.
Remove the 3 screws.
Remove the outer rear view mirror.
| 5.
REMOVE OUTER REAR VIEW MIRROR SUB-ASSEMBLY LH |
 |
Using a moulding remover, detach the 4 claws.
- HINT:
- Apply protective tape to the mirror body.
- Disconnect the mirror.
| 6.
REMOVE OUTER MIRROR COVER LH |
 |
- Using a screwdriver, detach the 8 claws and remove the mirror cover.
- HINT:
- Tape the screwdriver tip before use.
| 7.
REMOVE OUTER MIRROR COVER LOWER LH |
 |
Using a screwdriver, detach the 6 claws and remove the mirror cover lower.