REMOVAL
Removal / installation · Vehicles built from Aug 2008
Versions by build date: Nov 2005 – Jul 2008 from Aug 2008
| 1.
REMOVE RADIATOR SUPPORT OPENING COVER |
 |
Remove the 9 clips and radiator support opening cover.
| 2.
REMOVE CENTER HOOD CUSHION |
 |
- Using a clip remover, remove the center hood cushion.
| 3.
REMOVE RADIATOR GRILLE PROTECTOR |
 |
Remove the 2 radiator grille protectors.
| 4.
REMOVE FRONT FENDER FRONT SPLASH SHIELD LH |
 |
Remove the screw, bolt, nut and splash shield.
| 5.
REMOVE FRONT FENDER FRONT SPLASH SHIELD RH |
 |
- HINT:
- Use the procedure described for the LH side.
| 6.
REMOVE FRONT BUMPER COVER |
 |
Using a screwdriver, turn the pin hold clip 90° and remove the pin hold clip.
- HINT:
- Tape the screwdriver tip before use.
- Use the same procedure for the RH and LH sides.
Remove the retainer.
- HINT:
- Use the same procedure for the RH and LH sides.
- Put protective tape around the bumper cover.
Using a clip remover, remove the 4 clips.
Remove the 8 screws.
- Detach the 4 claws and remove the bumper cover.
w/ Fog Light:
Disconnect the 2 fog light connectors.
| 7.
REMOVE FRONT NO. 2 BUMPER ENERGY ABSORBER |
 |
Remove the energy absorber.


| 8.
REMOVE FRONT BUMPER ENERGY ABSORBER (w/ Front Bumper Lower Absorber) |
 |
Remove the 2 energy absorbers.
| 9.
REMOVE FRONT BUMPER LOWER ABSORBER (w/ Front Bumper Lower Absorber) |
 |
Remove the lower absorber.
| 10.
REMOVE FRONT BUMPER CENTER STAY SUB-ASSEMBLY |
 |
Remove the 2 bolts and stay.


| 11.
REMOVE LOW PITCHED HORN ASSEMBLY
|
 |
Disconnect the horn connector.
Remove the bolt and horn.
| 12.
REMOVE HIGH PITCHED HORN ASSEMBLY
|
 |
Disconnect the horn connector.
Remove the bolt and horn.
| 13.
REMOVE FRONT BUMPER UPPER REINFORCEMENT SUB-ASSEMBLY |
 |
Remove the 2 bolts and reinforcement.
| 14.
REMOVE FRONT BUMPER REINFORCEMENT |
 |
Detach the 3 clamps and remove the wire harness.
Remove the 8 bolts and reinforcement.


| 15.
REMOVE FRONT BUMPER SIDE RETAINER LH |
 |
Remove the bolt.
Using a clip remover, detach the clip and remove the retainer.
- HINT:
- Tape the clip remover tip before use.
| 16.
REMOVE FRONT BUMPER SIDE RETAINER RH |
 |
- HINT:
- Use the procedure described for the LH side.