REMOVAL
Removal / installation · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006 from Jan 2007
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- NOTICE:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2.
REMOVE NO. 1 CONSOLE UPPER PANEL GARNISH
|
 |
Using a screwdriver, detach the 4 clips and upper panel garnish.
- HINT:
- Tape the screwdriver tip before use.
| 3.
REMOVE NO. 2 CONSOLE UPPER PANEL GARNISH
|
 |
Using a screwdriver, detach the 4 clips and upper panel garnish.
- HINT:
- Tape the screwdriver tip before use.
| 4.
REMOVE SHIFT LEVER KNOB |
|
| 5.
REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
|
 |
Remove the shift lever knob.
for Manual Transaxle:
Using a screwdriver, detach the 2 clips, 4 claws and remove the upper console panel.
- HINT:
- Tape the screwdriver tip before use.
for Automatic Transaxle:
Using a screwdriver, detach the 2 clips, 4 claws and remove the upper console panel then disconnect the connector.
- HINT:
- Tape the screwdriver tip before use.
| 6.
REMOVE SWITCH BASE
|
 |
Detach the 2 clips and 2 claws.
Disconnect the connectors and remove the switch base.
| 7.
REMOVE CONSOLE CUP HOLDER BOX
|
 |
Remove the 2 screws.
Detach the 2 clips and remove the cup holder box.
| 8.
REMOVE UPPER REAR CONSOLE PANEL SUB-ASSEMBLY
|
 |
Using a screwdriver, detach the 4 clips.
- HINT:
- Tape the screwdriver tip before use.
Disconnect the connector and remove the upper rear console panel.
| 9.
REMOVE CONSOLE REAR END PANEL
|
 |
Using a screwdriver, detach the 6 claws and remove the console rear end panel.
- HINT:
- Tape the screwdriver tip before use.
| 10.
REMOVE REAR CONSOLE BOX SUB-ASSEMBLY
|
 |
Remove the console box carpet.
Remove the 2 bolts and 2 screws.
Disconnect the connector and remove the rear console box.
| 11.
DISCONNECT TRANSAXLE CONTROL CABLE ASSEMBLY |
 |
Remove the 2 clips, and disconnect the cable ends of the control cable.
- Using a screwdriver, release the cable locks of the shift cable and select cable.
- Turn the lock nuts 180° counterclockwise and hold them in that position. Remove the shift cable and select cable while holding them.
- NOTICE:
- Do not push in the cable locks.
| 12.
REMOVE FLOOR SHIFT SHIFT LEVER ASSEMBLY |
 |
Detach the 4 clamps and disconnect the wire harness.
- Remove the 4 bolts and shift lever.