2005-2008 RAV4 · Service Manual TRANSMISSION

REMOVAL

Removal / installation · Vehicles built from Jan 2007

Versions by build date: Nov 2005 – Dec 2006 from Jan 2007


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE NO. 1 CONSOLE UPPER PANEL GARNISH

B139541
  1. Using a screwdriver, detach the 4 clips and upper panel garnish.

    HINT:
    Tape the screwdriver tip before use.


3. REMOVE NO. 2 CONSOLE UPPER PANEL GARNISH

B139542
  1. Using a screwdriver, detach the 4 clips and upper panel garnish.

    HINT:
    Tape the screwdriver tip before use.


4. REMOVE SHIFT LEVER KNOB

5. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY

B129883
  1. Remove the shift lever knob.

  1. for Manual Transaxle:
    Using a screwdriver, detach the 2 clips, 4 claws and remove the upper console panel.

    HINT:
    Tape the screwdriver tip before use.

  1. for Automatic Transaxle:
    Using a screwdriver, detach the 2 clips, 4 claws and remove the upper console panel then disconnect the connector.

    HINT:
    Tape the screwdriver tip before use.


6. REMOVE SWITCH BASE

B129882
  1. Detach the 2 clips and 2 claws.

  1. Disconnect the connectors and remove the switch base.


7. REMOVE CONSOLE CUP HOLDER BOX

B129881
  1. Remove the 2 screws.

  1. Detach the 2 clips and remove the cup holder box.


8. REMOVE UPPER REAR CONSOLE PANEL SUB-ASSEMBLY

B129880
  1. Using a screwdriver, detach the 4 clips.

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the connector and remove the upper rear console panel.


9. REMOVE CONSOLE REAR END PANEL

B129879
  1. Using a screwdriver, detach the 6 claws and remove the console rear end panel.

    HINT:
    Tape the screwdriver tip before use.


10. REMOVE REAR CONSOLE BOX SUB-ASSEMBLY

B129878
  1. Remove the console box carpet.

  1. Remove the 2 bolts and 2 screws.

  1. Disconnect the connector and remove the rear console box.


11. DISCONNECT TRANSAXLE CONTROL CABLE ASSEMBLY

D026974E02
  1. Remove the 2 clips, and disconnect the cable ends of the control cable.

  1. D033170E04
    Using a screwdriver, release the cable locks of the shift cable and select cable.

  1. D033171E03
    Turn the lock nuts 180° counterclockwise and hold them in that position. Remove the shift cable and select cable while holding them.

    NOTICE:
    Do not push in the cable locks.


12. REMOVE FLOOR SHIFT SHIFT LEVER ASSEMBLY

C127220
  1. Detach the 4 clamps and disconnect the wire harness.

  1. C127079
    Remove the 4 bolts and shift lever.

← REMOVAL (Nov 2005 – Dec 2006)INSTALLATION (Nov 2005 – Dec 2006) →