2005-2008 RAV4 · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Jan 2007

Versions by build date: Nov 2005 – Dec 2006 from Jan 2007


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE NO. 1 ENGINE COVER

  1. A123518
    Detach the 4 clips and remove the engine cover.


3. REMOVE RADIATOR SUPPORT OPENING COVER
  1. Remove the 9 clips and cover.


4. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 4 bolts, 12 clips and engine under cover.


5. DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

6. REMOVE BATTERY CLAMP

A124917E01
  1. Remove the bolt and loosen the nut.

  1. Detach the 2 wire harness clamps.

  1. Detach the hook of the battery clamp from the front battery bracket , and then remove the battery clamp.


7. REMOVE BATTERY INSULATOR

8. REMOVE BATTERY

9. REMOVE FRONT BATTERY BRACKET

  1. A124918
    Detach the 2 wire harness clamps.

  1. Remove the 4 bolts and front bracket.


10. REMOVE BATTERY BRACKET REINFORCEMENT

  1. A124919
    Remove the 2 bolts and bracket reinforcement.


11. REMOVE AIR CLEANER CAP

  1. A129327
    Disconnect the mass air flow meter connector.

  1. Disconnect the wire harness clamp.

  1. Unhook the 3 hook clamps, and then remove the air cleaner cap.

  1. Remove the air cleaner element from the air cleaner case.


12. REMOVE AIR CLEANER CASE

  1. A129328
    Disconnect the wire harness clamp and remove the 3 bolts and air cleaner case.


13. DISCONNECT FUEL FILTER ASSEMBLY

  1. A134129
    Remove the bolt and fuel filter assembly.


14. REMOVE AIR CLEANER BRACKET

  1. A124933
    Remove the glow plug relay.

  1. Disconnect the fuel filter level switch connector.

  1. A124934
    Disconnect the 2 wire harness clamps.

  1. Disconnect the 2 fuel hoses from the bracket.

  1. Remove the 3 bolts and bracket.


15. REMOVE NO. 1 AIR TUBE

  1. A124904
    Remove the 2 bolts and disconnect the wire harness.

  1. A124905
    Remove the 2 bolts and loosen the 2 clamps.

  1. Remove the No. 1 air tube.


16. REMOVE NO. 3 AIR HOSE

  1. A124889
    Loosen the 2 hose clamps.

  1. Disconnect the No. 3 air hose from the No. 2 air tube and throttle body.


17. REMOVE STARTER ASSEMBLY

  1. A163980
    Disconnect the starter connector.

  1. Open the terminal cap, remove the nut and disconnect the starter wire.

  1. A163979
    Remove the 2 bolts and starter.

← REMOVAL (Nov 2005 – Dec 2006)DISASSEMBLY (Nov 2005 – Dec 2006) →