2005-2008 RAV4 · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built Nov 2005 – Dec 2006

Versions by build date: Nov 2005 – Dec 2006 from Jan 2007


1. REMOVE STARTER MAGNETIC SWITCH ASSEMBLY

  1. E110775
    Remove the nut, and disconnect the lead wire from the starter magnetic switch assembly.

  1. E110776
    Remove the 3 nuts and starter magnetic switch assembly.

  1. E110777
    Pull the plunger, and disconnect the plunger hook from the upper side of the starter pinion drive lever.


2. REMOVE STARTER DRIVE HOUSING ASSEMBLY

  1. E110778
    Using a T25 "torx" driver, remove the 2 bolts.

  1. A087882
    Using a screwdriver, remove the rubber seal from the starter pinion drive lever.

  1. E110779
    Remove the starter drive housing from the starter pinion drive lever.

  1. Pull out the yoke together with the armature.


3. REMOVE STARTER COMMUTATOR END FRAME ASSEMBLY

  1. A086441
    Remove the 2 screws and end frame.


4. REMOVE STARTER ARMATURE ASSEMBLY

  1. A030137
    Using a screwdriver, hold the spring back and disconnect the brush from the brush holder.

  1. Disconnect the 4 brushes, and remove the brush holder.

  1. A087883
    Remove the starter armature from the yoke.


5. REMOVE STARTER ARMATURE PLATE
  1. Remove the starter armature plate from the starter center bearing clutch.


6. REMOVE PLANETARY GEAR

  1. A087891
    Remove the 3 planetary gears.

← REMOVAL (from Jan 2007)DISASSEMBLY (from Jan 2007) →