INSTALLATION
Removal / installation · Vehicles built Nov 2005 – Jul 2008
Versions by build date: Nov 2005 – Jul 2008 from Aug 2008
| 1.
INSTALL FUEL PRESSURE REGULATOR ASSEMBLY |
 |
- Apply a light coat of gasoline to 2 new O-rings, and install them onto the fuel pressure regulator.
- Install the fuel pressure regulator to the fuel filter.
| 2.
INSTALL FUEL PUMP ASSEMBLY |
 |
- Connect the pump harness connector.
- Apply gasoline to a new O-ring and install the O-ring to the fuel filter.
Attach the 5 claws to the claw holes and install the fuel pump.
| 3.
INSTALL BRACKET |
 |
- Attach the 2 claws to the claw holes and install the bracket.
| 4.
INSTALL FUEL SUB-TANK ASSEMBLY |
 |
- Attach the 2 claws to the claw holes and install the sub-tank.
- Connect the wire harness.
- Install the 2 springs to the fuel suction plate shafts and install them to the sub-tank.
- Using needle-nose pliers, install a new E-ring.
- HINT:
- Slightly lower the sub-tank to install the E-ring.
| 5.
INSTALL FUEL SUCTION WITH PUMP ASSEMBLY |
 |
- Install a new gasket onto the fuel pump.
- Connect the fuel hose and install the fuel pump into the fuel tank.
- NOTICE:
- Do not damage the fuel pump filter.
| 6.
INSTALL FUEL TANK VENT TUBE SET PLATE |
 |
- Install the set plate with the 8 bolts.
-
Torque:
- 4.0 N*m{
41 kgf*cm
, 35 in.*lbf
}
| 7.
CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY |
 |
- Install the fuel tube with the joint clip.
- CAUTION:
- Check that there are no scratches or foreign objects on the connecting parts.
- Check that the fuel tube joint is inserted securely.
- Check that the fuel tube joint clip is on the collars of the fuel tube joint.
- After installing the tube joint clip, check that the fuel tube joint has not been pulled off.
- Be careful not to damage the clip. If the clip is damaged, replace it.
| 8.
CONNECT FUEL EMISSION HOSE |
 |
- Install the purge line hose, air inlet line hose and EVAP line tube to the fuel pump.
| 9.
INSTALL FUEL TANK ASSEMBLY |
 |
Install the fuel tank (Click here).