2005-2008 RAV4 · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built Aug 2007 – Jul 2008

Versions by build date: Aug 2007 – Jul 2008 from Aug 2008


1. INSTALL FUEL PRESSURE REGULATOR ASSEMBLY

  1. A097616E04
    Apply a light coat of gasoline to 2 new O-rings, and install them onto the fuel pressure regulator.

  1. A110141E01
    Install the fuel pressure regulator to the fuel filter.


2. INSTALL FUEL PUMP

  1. A126130
    Connect the pump harness connector.

  1. A131633E01
    Apply gasoline to a new O-ring and install the O-ring to the fuel filter.

  1. Engage the 5 claws to the claw holes and install the fuel pump.

    NOTICE:
    Do not damage the fuel pump filter.


3. INSTALL NO. 1 FUEL SUCTION SUPPORT

  1. A184625
    Engage the 2 claws to the claw holes and install the No. 1 fuel suction support.


4. INSTALL NO. 1 FUEL SUB-TANK

  1. A110138E02
    Apply gasoline to a new O-ring and install it to the jet pump.

  1. A130453
    Install the jet pump while aligning it to the installation position of the sub-tank.

  1. Install the jet pump nozzle.

  1. A185514
    Engage the 2 claws to the claw holes and install the fuel filter to the sub-tank.

  1. A126123
    Connect the wire harness.

  1. A126684
    Install the 2 springs to the fuel suction plate shafts and install them to the sub-tank.

  1. A126124E01
    Using needle-nose pliers, install a new E-ring.

    HINT:
    Slightly lower the sub-tank to install the E-ring.


5. INSTALL FUEL SUCTION WITH PUMP ASSEMBLY

  1. A126699E02
    Install a new gasket onto the fuel suction with pump assembly.

  1. A131634
    Connect the fuel hose and install the fuel suction with pump assembly into the fuel tank.


6. INSTALL FUEL TANK VENT TUBE SET PLATE

  1. A124675
    Install the set plate with the 8 bolts.

    Torque:
    4.0 N*m{ 41 kgf*cm , 35 in.*lbf }


7. CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY

  1. A124668
    Install the fuel tube with the joint clip.

    CAUTION:
    A124131E01
    1. Check that there are no scratches or foreign objects on the connecting parts.
    1. Check that the fuel tube joint is inserted securely.
    1. Check that the fuel tube joint clip is on the collars of the fuel tube joint.
    1. After installing the tube joint clip, check that the fuel tube joint has not been pulled off.
    1. Be careful not to damage the clip. If the clip is damaged, replace it.


8. CONNECT FUEL EMISSION HOSE

  1. A124674
    Install the purge line hose, air inlet line hose and EVAP line tube to the fuel pump.


9. INSTALL FUEL TANK ASSEMBLY
  1. Install the fuel tank (Click here).

← REMOVAL (from Aug 2008)INSTALLATION (from Aug 2008) →