2005-2008 RAV4 · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Aug 2008

Versions by build date: Aug 2007 – Jul 2008 from Aug 2008


1. INSTALL FUEL PUMP ASSEMBLY

  1. A195890
    Connect the fuel pump connector.

  1. A197087E02
    Install the fuel pump spacer to the fuel pump assembly.

  1. Apply gasoline to a new O-ring and install the O-ring to the fuel pump.

  1. A197085
    Attach the 5 claws to the holes to install the fuel pump.


2. INSTALL NO. 1 FUEL SUCTION SUPPORT

  1. A126126
    Attach the 2 claws to the holes to install the No. 1 fuel suction support.


3. INSTALL NO. 1 FUEL SUB-TANK

  1. A195888E02
    Apply gasoline to a new O-ring and install it to the jet pump.

  1. A130453
    Install the jet pump while aligning it with the installation position on the No. 1 fuel sub-tank.

  1. Install the jet pump nozzle.

  1. A126125
    Attach the 2 claws to the holes to install the No. 1 fuel sub-tank.

  1. A126123
    Connect the wire harness.

  1. A126684
    Install the 2 springs to the fuel suction plate shafts, and then install them to the No. 1 fuel sub-tank.

  1. A201342E01
    Using needle-nose pliers, install a new E-ring.

    HINT:
    Slightly lower the fuel suction plate to install the E-ring.


4. INSTALL FUEL SUCTION WITH PUMP ASSEMBLY

  1. A126699E02
    Install a new gasket onto the fuel suction with pump.

  1. A202412E01
    Connect the fuel hose with the paint mark facing towards the top of the vehicle, and then secure the clip.

  1. Install the fuel suction with pump into the fuel tank.

    NOTICE:
    Do not damage the fuel suction with pump.


5. INSTALL FUEL TANK VENT TUBE SET PLATE

  1. A124675
    Install the set plate with the 8 bolts.

    Torque:
    4.0 N*m{ 41 kgf*cm , 35 in.*lbf }


6. CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY

  1. A124668
    Install the fuel tube with the joint clip.

    NOTICE:
    A124131E05
    1. Check that there are no scratches or foreign objects on the connecting parts.
    2. Check that the fuel tube joint is inserted securely.
    3. Check that the fuel tube joint clip is on the collar of the fuel tube joint.
    4. After installing the tube joint clip, check that the fuel tube joint cannot be pulled off.
    5. Be careful not to damage the clip. If the clip is damaged, replace it.


7. CONNECT FUEL EMISSION HOSE

  1. A203591E01
    Connect the purge line hose, air inlet line hose to the fuel suction plate.

  1. Connect the fuel emission hose to the fuel suction plate.

    HINT:
    Firmly push the tube connector until a "click" sound is heard.

    NOTICE:
    1. Before connecting the hose, check if there is any damage or foreign matter in the hose or connector.
    2. Check that the connector is connected by pulling on it.


8. INSTALL FUEL TANK ASSEMBLY
  1. Install the fuel tank assembly (Click here).

← INSTALLATION (Aug 2007 – Jul 2008)COMPONENTS (from Aug 2007) →