INSPECTION
Inspection · Vehicles built Aug 2007 – Jul 2008
Versions by build date: Aug 2007 – Jul 2008 from Aug 2008
| INSPECT FUEL PUMP |
Check the resistance.
Using an ohmmeter, measure the resistance according to the value(s) in the table below.

- Standard resistance:
Tester Connection
Condition
Specified Condition
1 - 2
20°C (68°F)
0.2 to 3.0 Ω
Check the operation.
Apply battery voltage to both terminals. Check that the pump operates.
- NOTICE:
- These tests must be done quickly (for less than 10 seconds) to prevent the coil from burning out.
- Keep the fuel pump as far away from the battery as possible.
- Always do the switching on the battery side.
- These tests must be done quickly (for less than 10 seconds) to prevent the coil from burning out.
