DISASSEMBLY
Removal / installation · Vehicles built Aug 2007 – Jul 2008
| 1.
REMOVE NO. 1 FUEL SUB-TANK |
 |
- Disconnect the wire harness.
- NOTICE:
- Do not damage the wire harness.
- Do not separate the tube indicated in the illustration (Click here).
- Using needle nose pliers, remove the E-ring.
- HINT:
- Slightly lower the sub-tank to remove the E-ring.
- Remove the 2 springs from the 2 shafts.
- Disengage the 2 claws and separate the sub-tank.
- Disengage the claw of the jet pump nozzle.
Using a screwdriver with the tip taped, remove the jet pump.
- Remove the O-ring from the jet pump.
| 2.
REMOVE NO. 1 FUEL SUCTION SUPPORT |
 |
- Using a screwdriver, disengage the 2 claws and remove the No. 1 fuel suction support.
- HINT:
- Tape the screwdriver tip before use.
| 3.
REMOVE FUEL PUMP |
 |
- Disengage the 5 claws on the filter and remove the fuel pump from the fuel filter.
- HINT:
- When disengaging the claws, do not disconnect the fuel main tube.
- Disconnect the fuel pump connector.
- Remove the O-ring from the fuel filter.